Arrows on graph paper
Every vector in this simulation is a coloured arrow drawn to scale on squared paper. Its length shows the size and its angle shows the direction, measured anticlockwise from the +x axis, so 0° points right and 90° points up. The badge in the corner gives the scale, such as one square for 1 N. Grab the round handle on any tip and drag it, or pick a vector in the panel and set its size and direction with the sliders. The arrows can stand for forces in newtons, displacements in kilometres or velocities in metres per second, and the maths is the same for all three.
Head-to-tail addition
Press Head-to-tail and each arrow slides along until its tail sits on the tip of the one before. The glowing red resultant then grows from the very start of the chain to its final tip. Swap reverses the order: the arrows take a different path, but they finish at the same point, because vector addition does not depend on order. With two vectors drawn from one start, the Parallelogram view completes the shape with dashed sides, and its diagonal is the same resultant.
Three cases deserve special attention. Two vectors pointing the same way simply add. Pointing in opposite directions, the smaller is taken from the larger, and the resultant follows the larger one. At 90° to each other they form a right-angled triangle, so . For any other angle the sim adds up the components instead, as explained below.
Checking a scale drawing
Scale drawing (grid, protractor and ruler) turns the stage into a drawing board. A see-through protractor sits on the start point and a ruler lies along the resultant, marked in squares. Read the length in squares, multiply by the scale, and you have the size. Read the angle where the resultant crosses the protractor and you have the direction. A teacher can hide the resultant in a lesson link, and students then find it from the drawing themselves.
Splitting a vector into components
In Resolve mode a single vector is split into two parts at right angles. Press Components and a dotted line drops from the tip to the x-axis, then dashed arrows mark the two sides of the right-angled triangle, with a small square at the corner:
A component can be negative. An 8 N force at 120° leans left, so its x-part is −4.00 N. The table in add mode lists the parts of every vector and adds each column, which is exactly where the head-to-tail chain ends.
Reverse runs the method backwards. You set the two components and the sim builds the vector: , and the angle comes from of their sizes. The signs then decide the quadrant, so −3 N and −4 N give 5 N at 233.1°, not 53.1°.
Parallel forces on a bar
The last mode puts two or three upward or downward forces on a wooden bar. Like parallel forces point the same way and add; unlike ones point opposite ways, so the smaller total is taken from the larger, and the resultant follows the larger. A side column stacks the same arrows head-to-tail along one line. Sliding a force along the bar never changes the resultant, but it can change whether the bar turns. Two equal, opposite forces at different points cancel completely as forces, yet they still turn the bar: they form a couple. To explore turning properly, open the principle of moments simulation, and to see forces acting on one object, try the free-body diagram simulation.