What this simulation shows
Pick an object, a planet and a drop height, then let go. The object heads for the ground while the simulation tracks its height, velocity and acceleration, and plots a velocity–time graph as it goes. You can turn air resistance off, use a simple model in which drag is proportional to speed, or use a more realistic model in which drag grows with the square of speed.
Downwards counts as positive throughout, so a falling object has a positive velocity. A negative acceleration means the object is slowing down while still moving down.
Two forces on a falling object
Once an object has been released, two forces matter. Its weight pulls it down and is found from . Air resistance, also called drag, pushes against the direction of motion, so for a falling object it acts upwards. The arrows on the stage show both forces, plus the resultant, which is weight minus drag.
That resultant decides the acceleration: . At the moment of release the object is not yet moving, so there is no drag and the acceleration equals .
Why terminal velocity happens
Drag depends on speed. As the object gains speed, the drag arrow lengthens while the weight arrow stays put. The resultant shrinks, so each extra metre per second takes longer to gain. Eventually drag grows as large as the weight. With the two forces balanced, the acceleration drops to zero and the velocity stops changing. This steady speed is the terminal velocity.
The readout gives the terminal velocity calculated for the model you chose, and the moment the object comes within 1% of it. A short drop can end before that happens.
Reading the velocity–time graph
Acceleration shows up as the slope of the velocity–time graph. Without air the graph is a straight line, because the acceleration never changes from . With air resistance the line begins with that same gradient, then bends over and levels off as it closes in on the terminal velocity. Use the tangent tool to measure the gradient at several times and compare each value with the acceleration readout. The motion graphs simulation explores gradients and areas in more detail.
Opening the parachute
Choose the skydiver and press the parachute button partway down. The canopy greatly increases the area facing the air, so drag suddenly becomes far larger than weight. The resultant now points upwards and the skydiver decelerates, even though the motion is still downwards. As the speed falls, so does the drag, until the forces balance again at a new, much lower terminal velocity. Here the canopy takes about 2.5 s to fill, which keeps the deceleration to a few times , as happens with a real parachute.
Falling without air
Choose the Moon, drop the hammer and add the feather beside it. With no atmosphere there is no drag, so each object feels only its weight. A heavier object has a bigger weight but also more mass to accelerate, and the two effects cancel exactly, so everything falls with the same acceleration. Astronaut David Scott showed this on the Moon during the Apollo 15 mission in 1971. Repeat the drop on Earth to see how much the air matters.
Two models of drag
The linear model, , is easy to analyse and gives a terminal velocity of . The quadratic model, , is closer to how air behaves at everyday speeds, and its terminal velocity is . The air densities, drag coefficients and areas are model values of the right size, not measurements, and the air density is treated as constant with height. Mars has a far thinner atmosphere than Earth, so objects there reach much higher terminal velocities.