What this simulation shows
A wooden metre rule turns on a steel pin, with a tray of slotted brass masses on the bench below it. Hang masses from the rule, slide them along the printed scale and let go. The rule either stays level or swings down onto one of its rubber stops. Above the pivot, two glowing curved arrows show the turning effects: the left arrow for anticlockwise moments and the right one for clockwise moments. A bigger moment draws a longer, thicker arrow.
A second scene swaps the rule for a playground see-saw, so you can test the same idea with two children instead of brass masses.
Working out each moment
Each hanging weight tries to turn the rule about the pin. Its moment is the weight multiplied by its perpendicular distance from the pivot, measured to the vertical line along which that weight acts:
With force in newtons and distance in metres, the moment comes out in newton metres (N m). The readout under the stage lists every weight on each side with its multiplication written out, then adds up each column. Anything hanging exactly at the pivot is listed on its own, because its distance, and so its moment, is zero.
When the two column totals match, nothing is left over to turn the rule, and it is balanced. That is the principle of moments.
Holding and letting go
In a school lab you steady the rule while you hang the masses, then let go to test it. The simulation copies that. Two rubber-tipped pegs keep the rule level until you press Release. Change anything after that and the pegs lift it level again briefly, then drop away.
When the moments are unequal, the rule speeds up as it turns. Its angular acceleration is the leftover moment divided by its moment of inertia, which depends on how much mass sits how far from the pin. Friction at the pin and the air slow the motion down, so after a small bounce the rule settles on a stop. When the moments are equal, nothing starts it turning, so it stays level and glows green.
Does tilting change the answer?
No. While the rule rests at an angle, each weight's perpendicular distance from the pivot is shorter than its distance along the rule. Every one of those distances shrinks by the same factor, cos θ, so both totals shrink together. Totals that were equal when level are still equal when tilted. That is why the readouts quote level values, which match the numbers you would read off the scale.
Finding something hidden
Two of the ready-made situations hide a value. In Find an unknown weight, one mass carries a question mark. Move the known weight until the rule balances. Both sides now have the same total moment, so divide the known side's total by the hidden weight's distance from the pivot.
In Find the weight of the rule, the pin sits at the 30 cm mark. The rule's own weight acts at its 50 cm mark, its centre of mass, so it now has a moment too. Balance it and you can calculate what the rule weighs. Press Reveal to check.
The push from the pivot
A balanced rule has no resultant force either. The pin must push upwards with a force equal to everything pulling down, the rule's own weight included. A green arrow at the pivot shows this force whenever the rule balances.
Weights or masses
You can give sizes as weights in newtons or as masses in grams. Each mass is turned into a weight with , using the value of g from your course. Some courses call a moment a torque and write it as τ. Pick your course below the simulation to see its own letters.