Centre of Mass and Stability: Why Do Things Topple Over?
Find the centre of mass of regular and irregular shapes, see why an object topples once its weight acts outside its base, and learn how a wide base and a low centre of mass keep cars, buses, lamps and ships upright.
Published · 8 min read
On this page
Every object has one special point, its centre of mass, where its whole weight can be treated as acting. Many courses call it the centre of gravity. Close to the Earth's surface, both names describe the same point. In a uniform shape with symmetry, such as a ruler, a brick or a football, it sits at the centre. For an irregular flat card, you can find it by hanging the card from two different points and using a plumb line.
An object topples if the vertical line through its centre of mass passes outside its base. This line is the line of action of the weight. Once it is outside, the weight has a moment that turns the object over. While it stays inside, the weight turns the object back onto its base.
So two things make an object hard to topple: a broad base and a low centre of mass. This explains why racing cars are flat, why lamps have heavy bases and why ships carry ballast.
What is the centre of mass?
Gravity pulls on every particle of an object. Add all of these small pulls and you get the object's weight. The centre of mass is the point where this total weight seems to act. On a force diagram, you draw the weight as one arrow, starting at the centre of mass and pointing straight down.
For uniform objects, symmetry tells you where it is:
- Metre rule: at the 50 cm mark.
- Rectangular sheet: where the two diagonals cross.
- Disc or ring: at the centre of the circle.
- Triangular card: where the lines from each corner to the middle of the opposite side meet.
The centre of mass does not have to be inside the material. For a ring, a horseshoe or a boomerang, it is in the empty space. A high jumper who arches backwards over the bar can clear it while their centre of mass passes just below it.
How do you find the centre of mass of an irregular card?
A card hanging freely from a pin always settles with its centre of mass straight below the pin. Then the weight acts through the pin and has zero moment about it. So a vertical line drawn down from the pin passes through the centre of mass, and two such lines cross at it.
- Make three small holes near the edge of the card, well spread out.
- Push a pin through one hole and clamp it so the card swings freely.
- Hang a plumb line, a thread with a small weight on the end, from the same pin.
- When everything is still, mark two points under the thread, far apart, and join them with a ruler.
- Repeat with the second hole. The centre of mass is where the two lines cross.
- Repeat with the third hole as a check. Its line should pass through the same point.
The card should also balance on a pencil tip placed at that point. Make each hole a little wider than the pin, so the card swings freely.
Why do objects topple?
Tilt a tall box onto one bottom edge and let go. That edge acts as a pivot. What happens next depends on where the line of action of the weight is:
- Inside the base: the weight has a moment that turns the box back. It falls back onto its base.
- Exactly over the edge: the weight passes through the pivot and has zero moment. The box balances briefly, and the smallest nudge decides which way it goes.
- Outside the base: the weight's moment turns the box further over. It topples.
The Leaning Tower of Pisa in Italy leans by about 4°. It stays up because the vertical line through its centre of mass still falls inside its base.
Worked example 1: tipping a bookcase
A uniform bookcase in Tokyo is 1.8 m tall and 0.30 m deep. Its weight is 500 N. A child pulls horizontally on its top edge. Find the smallest pull that starts to tip it forwards over its front bottom edge. Assume it does not slide.
Given: W = 500 N. The bookcase is uniform, so its centre of mass is halfway back: 0.15 m from the front edge. The pull acts 1.8 m above the floor.
Pivot: the front bottom edge. Just as it tips, the floor pushes only at this edge, so that force has no moment.
Principle of moments: moment of the pull = moment of the weight
Substitution:
Answer: , or about 42 N
That is roughly the weight of a 4 kg bag of rice. This is why tall, narrow furniture is often fixed to the wall, especially in earthquake zones such as Japan. A unit of the same weight but twice as deep would need twice the pull, about 83 N.
What makes an object more stable?
When you tilt an object, its centre of mass moves sideways. A high centre of mass moves sideways a long way for a small tilt; a low one moves only a little. A wide base gives the line of action more room before it reaches the edge. Both mean a bigger tilt is needed to topple the object.
Worked example 2: how far can it tilt?
This extension uses the tangent from trigonometry. A display stand in a shop in Nairobi has a base 0.40 m wide, and its centre of mass is above the middle of the base. When empty, its centre of mass is 0.50 m above the floor. With sandbags in its base, the centre of mass drops to 0.25 m. Find the largest tilt before it topples in each case.
Idea: it is on the point of toppling when its centre of mass is directly above the bottom edge. Then .
Empty: , so θ = 22°
With sandbags: , so θ = 39°
Answer: halving the height of the centre of mass nearly doubles the safe tilt, from 22° to 39°.
How do engineers keep things upright?
- Racing cars sit only a few centimetres above the track, and their wheels are set far apart.
- Double-decker buses. In the UK, a new double-decker must pass a tilt test. With weights on the upper deck to stand in for passengers, it is tilted to 28° and must not tip over. The engine and fuel tank sit low down to help.
- Table lamps have a heavy, wide base, so the line of action stays inside it even when the arm stretches out.
- Ships carry ballast, such as water in tanks, low in the hull to keep the centre of mass low. Cargo on deck is loaded with care, because stacking it high raises the centre of mass.
- People. A judo player spreads their feet and bends their knees: a wider base and a lower centre of mass. A lorry piled high with hay does the opposite, and can tip on a sharp bend.
What are stable, unstable and neutral equilibrium?
The Punjab Class 9 course uses these three terms.
- Stable equilibrium: after a small tilt, the object returns. Tilting it raises its centre of mass. Example: a cone standing on its flat base.
- Unstable equilibrium: after a small tilt, it falls further. Tilting it lowers its centre of mass. Example: a cone balanced on its point.
- Neutral equilibrium: it stays in its new position. Its centre of mass stays at the same height. Example: a ball on a level floor.
The centre of mass and stability simulation lets you explore these ideas.
In the principle of moments simulation, choose Find the weight of the rule. The pivot sits at the 30 cm mark, so the rule's own weight, acting at its 50 cm mark, has a moment. Balance the rule, then work out its weight.
Common mistakes
- Saying the centre of mass is always in the middle. That is only true for uniform, symmetrical objects.
- Saying it must be inside the object. For a ring or a horseshoe, it is not.
- Saying an object topples when its centre of mass is "outside the base". It is the vertical line through the centre of mass that matters.
- Assuming heavier means more stable. A heavy object with a high centre of mass and a narrow base can still tip easily.
- Marking the plumb line while the card still swings.
- Using two holes close together. The lines cross at a shallow angle, so a small error moves the crossing point a long way.
Key points
- The weight of an object can be treated as acting at its centre of mass. Near the Earth, this is also its centre of gravity.
- Uniform, symmetrical objects have it at their centre. For an irregular card, hang it from two or more points and use a plumb line.
- If the vertical line through the centre of mass passes outside the base, the object topples.
- Widening the base and lowering the centre of mass both increase stability.
- Stable, unstable and neutral equilibrium describe whether a small tilt raises, lowers or keeps the height of the centre of mass.