Four set-ups
Under Set-up you can switch between four views of the magnetic effect of a current. Straight wire puts you above a horizontal card with a vertical copper wire through its centre. Solenoid shows a coil from the side, sliced along its axis so the field inside is visible. Electromagnet stands the same coil on end over a dish of paperclips, and Relay uses an electromagnet to work a switch.
Looking down on a wire
Seen from above, the wire is a copper dot with a symbol on it. A small dot means the current is heading up towards you; a cross means it is heading down, away from you. The picture in the corner of the card shows the real arrangement, so you can link the flat view to the three-dimensional apparatus.
Round the wire, the field lines form rings with the wire at their middle. Their arrows follow the right-hand grip rule: with your thumb along the current, your curled fingers show the way the field goes round. Each gap between two neighbouring circles holds the same amount of field, so the circles spread out as the field fades away from the wire. More current packs in more circles. For a long wire the strength is
which goes beyond GCSE and IGCSE, and the graph under the stage plots it against the distance .
Eight plotting compasses start in a ring. Drag any of them, or choose one in the panel and use its distance and direction sliders. Their needles swing and settle along the field. Iron filings give the whole pattern in one go but cannot show which way it points. The Earth button adds a steady field of about 19 microtesla pointing up the card, a rough value for the horizontal part of the Earth's field in the UK, so distant compasses turn northwards and a neutral point appears where the two fields cancel.
Inside and around a solenoid
Every line in the solenoid view is a true field line, traced step by step. Inside the coil the lines are crowded and almost parallel, showing a strong, uniform field. They leave one end, sweep round the outside like the field of a bar magnet, and re-enter at the other end. The N label sits where they come out. Look straight at that end and the current would be going round anticlockwise. The graph of field strength along the axis is nearly flat in the middle, drops to about half at each end and fades outside. Its dashed line marks the value for a very long coil, .
Electromagnets, soft iron and steel
An iron core turns the coil into an electromagnet. The coil magnetises the iron, which adds a far bigger field of its own. In the Electromagnet set-up the clips jump up to the tip of the core, and Record writes the turns, current, core and clip count into a results table, as you would in the practical. With only air inside, even the strongest setting holds no clips. Soft iron lets go of everything once the current stops. Steel keeps part of its magnetism and goes on holding some clips, because it has become a permanent magnet. Demagnetise passes an alternating current that dies away to nothing, flipping the steel back and forth more weakly each time until no magnetism is left.
How the model works
The winding is treated as a smooth sheet of current, and its field is calculated exactly with elliptic integrals. A core is modelled as evenly magnetised, with a strength that rises with the coil's field and levels off as the iron saturates. The number of clips held is a model linked to the field at the tip, not a measured value.