Fleming's Left-Hand and Right-Hand Rules: Which Hand for Motors and Which for Generators
Learn when to use Fleming's left-hand rule and when to use the right-hand rule, what the thumb and two fingers stand for, how the right-hand grip rule is different, and why the force on an induced current always opposes the motion. Four worked examples, each checked.
Published · 8 min read
On this page
Use your left hand when a current is already flowing in a magnetic field and you want the direction of the force on it. That is the motor effect, so the left-hand rule is the rule for motors. Use your right hand when a wire is moved through a magnetic field and you want the direction of the current induced in it. That is the generator effect, so the right-hand rule is the rule for generators.
Both rules use the thumb and the first two fingers, held at right angles to each other. Each digit means the same thing in either hand:
- Thumb: the motion. In the left-hand rule, this is the force that pushes the wire.
- First finger: the magnetic field, which runs N to S.
- Second finger: the conventional current, from + to −.
The right-hand grip rule is a third, separate rule, with no force or motion in it. It gives the direction of the magnetic field around a wire or coil carrying a current.
Which hand do you use, and when?
| Rule | Hand | You know | It gives you | Typical use |
|---|---|---|---|---|
| Fleming's left-hand rule | Left | The field and the current | The direction of the force | Motors, loudspeakers |
| Fleming's right-hand rule | Right | The field and the motion | The direction of the induced current | Generators, dynamos |
| Right-hand grip rule | Right | The direction of the current | The direction of its magnetic field | Wires, solenoids |
What does each finger stand for?
Hold the thumb straight up, point the first finger ahead and bend the second finger across your palm. The three now sit at right angles, like the axes of a 3D graph.
- The thumb is a hitchhiker's thumb. It shows which way something travels. In the left-hand rule, it is the way the wire gets pushed. In the right-hand rule, it is the way you move the wire.
- The first finger points like a compass needle. A compass in the field would point the same way, from N towards S.
- The second finger takes the one that remains: the current. Use conventional current, from + to −. Electrons drift the opposite way.
Both rules are set up for a field at 90° to the current, or to the motion. A current running parallel to the field lines feels nothing, and a wire sliding along the lines induces nothing.
To check the examples, take x to the right, y up the page and z out of the page, towards you. A cross product (beyond GCSE) gives the same answers as the hands, with , and . Swapping the order flips the sign.
How do you use the left-hand rule?
The force on a current is , where points along the conventional current.
Worked example 1: the push on a current
A current flows to the right along a wire. The magnetic field points into the page. Find the direction of the force on the wire.
First finger: into the page, along the field.
Second finger: to the right, along the current.
Thumb: up the page.
Answer: the wire is pushed up the page.
Check: , which is up the page.
Worked example 2: finding the field
In a test rig in Lahore, a wire carries a current out of the page, towards you. It is pushed to the left. Which way does the field point?
Thumb: to the left, along the force.
Second finger: out of the page, along the current.
First finger: this leaves up the page.
Answer: the field points up the page, so the N pole is below the wire and the S pole is above it.
Check: , which is to the left, as given.
How do you use the right-hand rule?
Now something else moves the wire: a hand, a turbine or a crank. The movement pushes on the free electrons, so a p.d. is induced across the ends of the wire. Join the ends in a circuit, and a current flows along , where is the velocity of the wire.
Worked example 3: the current from a moving wire
Keep the field from example 1, pointing into the page. There is no cell now: the ends of the wire are joined through a lamp. A student in Manchester pulls the wire down the page. Which way does the current flow along it?
Thumb: down the page, along the motion.
First finger: into the page, along the field.
Second finger: to the right.
Answer: the induced current flows to the right.
Check: , which is to the right.
If the magnet moves and the wire stays still, the thumb shows how the wire moves relative to the magnet. So point it opposite to the magnet's movement.
How does Lenz's law link the two rules?
Look again at example 3. The induced current flows to the right, in a field pointing into the page. That is the situation in example 1, so the motor effect pushes the wire up the page, against the student's pull.
This always happens. The force on an induced current opposes the motion that caused it. This is Lenz's law: an induced current always acts against the change that produces it.
It is also why the two rules need different hands. Point the first and second fingers of both hands the same ways, and the thumbs point in opposite directions. So the force from the left hand is always opposite to the motion from the right hand.
Energy demands it. If the force helped the motion, the wire would speed up, the current would grow and the lamp would glow for free. Instead, the student must do work against the force, and that work is transferred to the lamp.
What is the right-hand grip rule for?
The grip rule answers a different question: which way does the field around a current go?
- Straight wire: wrap your right hand round the wire, thumb pointing along the conventional current. The curled fingers show the direction of the circular field lines.
- Solenoid: let your fingers follow the current around the turns. The thumb then points to the N end of the coil.
Worked example 4: the field on each side of a wire
A long, straight wire runs up the page, with the current flowing upwards. What is the direction of the field (a) just to the right of the wire and (b) just to the left?
Grip: thumb up the page. Your fingers go into the page on the right of the wire, and come back out on the left.
Answer: (a) into the page and (b) out of the page.
Check: the field at a point lies along , where points from the wire to that point. On the right, . On the left, .
These field patterns are also covered by a simulation of the field round a wire and a coil.
Practise in the motor effect simulation. Wire in a field opens with a left hand drawn on the stage. Press Hand rule to hide it, press Reverse I or Flip magnet, work out the new push yourself, then show the hand again to check. For Lenz's law, press Push in the electromagnetic induction simulation: the Coil end facing the magnet card shows a pole that repels the incoming magnet. Press Pull, and the new pole pulls on it.
Common mistakes
- Using the wrong hand. Left for the force on a current, right for an induced current. Swapping them reverses the answer.
- Following the electrons. The second finger shows conventional current, from + to −.
- Pointing the field from S to N. The first finger points from N to S.
- Mixing up the two right-hand rules. The grip rule gives a field. Fleming's right-hand rule gives an induced current.
- Using the magnet's motion. The thumb shows how the wire moves relative to the field.
Key points
- Left hand for motors: the force on a current. Right hand for generators: the current that a movement induces.
- Thumb for the motion, first finger for the field (N to S), second finger for the conventional current.
- The grip rule is different: thumb along the current, curled fingers along the field.
- The force on an induced current always opposes the motion (Lenz's law), which is why the Fleming rules use mirror-image hands.