Two experiments on one bench
The simulation has two set-ups, chosen under Experiment. In Magnet and coil, a bar magnet lies on the bench beside a 6 cm coil of copper wire, and the coil's two leads run to a centre-zero meter. Press Push and the magnet slides into the coil at the speed you set; Pull takes it back out. You can also drag the magnet with a finger or a mouse, or use the arrow keys. Below the bench, a green trace scrolls across a small oscilloscope screen, so every movement leaves a record you can compare.
In Generator, a rectangular coil spins between the N and S poles of two magnets. Its ends connect to the circuit through rings and carbon brushes, with the same meter and a small lamp.
What the needle is telling you
Watch the needle closely during a push. It stays on zero while the magnet is far away, swings right as the N pole enters, then drifts back to zero as the magnet settles in the middle. The reading depends on how fast the magnetic field threading the turns is changing, not on how much field there is. That is why a magnet resting inside the coil, with the most field passing through it, gives no reading at all.
Three settings make the swing bigger: a higher speed, a stronger magnet and more turns on the coil. Doubling the speed doubles the height of the hump on the trace and squeezes it into half the time. The area under the hump stays the same, because the total change of field is the same however quickly you make it.
Which way the current flows
Pulling the magnet out sends the needle the other way, and so does pushing it in again after turning it round with Flip. Leave the coil's poles switched on under Show and the ends of the coil light up as N or S while current flows. During a push, the end facing the magnet becomes the same pole as the one approaching, so the coil repels it. During a pull it becomes the opposite pole and pulls back on the magnet. Either way the coil resists what you are doing, so moving the magnet takes work, and that work is where the electrical energy comes from.
Inside the generator
Each long side of the spinning coil is a wire sweeping through the field. When the coil's plane is upright, at right angles to the field, those sides glide along the field lines and the output is zero. A quarter of a turn later the plane lies parallel to the field, the sides cross the lines head on, and the output reaches its peak. Small coil symbols along the top of the trace mark these positions as the wave is drawn. Turning faster gives taller peaks and more cycles per second.
Slip rings or a split ring
With slip rings, each end of the coil keeps its own brush, so the output reverses every half turn: alternating current. A split ring swaps the coil's connections every half turn, at the instants the output is zero, so the current in the circuit always flows one way and the trace becomes a row of humps.
The model behind the numbers
The magnet is the one from the bar magnet simulation, treated as two poles. The flux through each turn is calculated from that pole model, and the induced e.m.f. follows Faraday's law, . The generator uses a uniform field of 0.20 T and a coil of area m², so its peak e.m.f. is , about 0.75 V at one turn per second with 200 turns. These are typical values, not measurements, and the course note under the stage says which parts your course needs.