Skip to content

Cambridge IGCSE Physics (0625) · Magnetism and electromagnetic effects

Force on a current-carrying conductor

4.5.4

Core: a magnet's field pushes on a wire while a current flows in it; reversing the current or the field reverses the push, and reversing both leaves it unchanged. Supplement: Fleming's left-hand rule relates force, field and current, and predicts how a beam of charged particles bends.

Loading simulation…

Symbols match your course. Open the full the motor effect simulation for more presets and teacher tools.

What this topic covers

A ceiling fan in Dhaka, a car's starter motor in Toronto and a phone speaker all rely on one effect: a wire carrying a current is pushed when it sits in a magnetic field. Syllabus 4.5.4 covers that push on one straight wire; spinning coils are on the d.c. motor page.

Showing the force (Core)

A light copper rod rests across two bare copper rails. A U-shaped magnet sits with one pole above the rod and the other below it, so its field passes vertically through the rod. The rails are joined through a switch to a low-voltage d.c. supply.

  1. Close the switch: the rod rolls along the rails, so a force acts on it.
  2. Swap the leads at the supply to reverse the current. The rod rolls the opposite way.
  3. Put the leads back and turn the magnet over so its poles swap places. Again the rod rolls the opposite way.
  4. Reverse the current and the field together: the rod goes the same way as in step 1.

Close the switch only briefly: the rod and rails are almost a short circuit, so they heat up fast. With no current, or no magnet, the rod stays put. A larger current or a stronger magnet gives a bigger push.

Fleming's left-hand rule (Supplement)

Hold out your left hand with its thumb and first two fingers all at right angles. Line up the first finger with the field, from N towards S, and the second finger with the conventional current, from + round to −. The thumb then shows the force: the wire moves that way.

The rule needs the current to cross the field at right angles; a wire lying along the field lines is not pushed.

Worked example: predicting the push (Supplement)

A diagram shows an N pole above a wire and an S pole below it. Current flows into the paper along the wire. Which way is the wire pushed?

  1. Field: N to S, so down the page. First finger downwards.
  2. Current: into the paper. Second finger pointing away from you.
  3. Force: your thumb points to the left.

With the current out of the paper, the push is to the right. Turn the magnet upside down too and it is left again.

Beams of charged particles (Supplement)

Moving charges are a current even without a wire, so a magnetic field pushes on them. The push is always at right angles to their motion, so the beam bends into a curve. For positive particles, point your second finger the way they travel. For electrons, point it the opposite way, as conventional current runs against the electron flow.

Electrons travel from left to right across a field pointing into the page. Conventional current: right to left. First finger into the page, second finger to the left: the thumb points down, so the beam curves downwards. Positive particles moving the same way would curve upwards.

In the simulation above

In the simulation above, Wire in a field opens with a copper rod hanging in a U-shaped magnet's gap, N on the left. Field strength is 0.5 T and Current is 2 A, drawn in violet and flowing out of the screen. Hand rule is already pressed, so a left hand in the corner follows every change.

  1. (Core) The rod is pushed up. Press Reverse I: now it is pushed down. Press Flip magnet too: back up.
  2. (Core) Raise Current, then Field strength: the force arrow grows. Take either to zero and the force vanishes, then raise it again.
  3. (Supplement) Press Hand rule to hide the hand. Before each press of Reverse I or Flip magnet, predict the push with your own left hand, then check the Direction of the force card.
  4. (Supplement) Under Moving charges, choose Electrons: the dots now drift the opposite way to the conventional current, which is how electrons move in a wire or a beam.

The force values, the F = BIL working and the tesla go beyond 0625. So does Turn the wire to an angle.

Common mistakes

  • Thinking that reversing the current and the field together reverses the force. Each change on its own reverses it, so making both changes turns it back to where it started.
  • Believing that a larger current or a stronger magnet can change the direction of the push. They change only its size; the direction changes only when the current or the field is reversed.
  • Describing the copper wire as being attracted towards one of the poles, as if it were iron. Copper is not a magnetic material: the push appears only while current flows, and it acts across the field, not towards a pole.
  • (Supplement) Using the right hand instead of the left for the force on a current. The left hand is the one for this effect; the right hand gives the wrong answer.
  • (Supplement) Pointing the second finger along the way electrons move. The rule uses conventional current, which flows the opposite way to electrons, so for an electron beam the finger points against the beam.
  • (Supplement) Trying to use the rule for a wire that lies along the field lines. A wire parallel to the field is not pushed at all; the rule needs the current to cross the field at right angles.

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A student in Nairobi lays a light copper rod across two horizontal copper rails. A strong magnet is arranged so that its field passes vertically through the rod. The rails are connected to a low-voltage d.c. supply through a switch.

    1. (a)State what is seen when the switch is closed.

      1 mark
      Show the answer

      Answer: The rod rolls (moves) along the rails.

      Marking points

      • the rod moves / rolls along the rails (accept: a force acts on the rod)
    2. (b)Suggest why the switch should be closed for only a short time.

      1 mark
      Show the answer

      Answer: The rod and rails are almost a short circuit, so the current is large and they quickly become hot.

      Marking points

      • large current / almost a short circuit, so the rod (rails, supply) gets hot
    3. (c)The magnet is taken away and the switch is closed again. State what happens to the rod and explain why.

      2 marks
      Show the answer

      Answer: The rod does not move. A force needs both a current and a magnetic field, and now there is no field.

      Marking points

      • the rod stays still / does not move
      • the force needs a magnetic field as well as a current (there is no field now)
    4. (d)The magnet is put back. State one change the student could make so that the rod is pushed with a bigger force.

      1 mark
      Show the answer

      Answer: Use a larger current, or use a stronger magnet.

      Marking points

      • larger current / stronger magnet (stronger field)
  2. 2.A teacher in Lima hangs a short length of bare copper wire from two thin, flexible leads so that it hangs between the two poles of a horseshoe magnet. The leads go to a low-voltage d.c. supply and a switch.

    1. (a)Describe how the teacher uses this apparatus to show that a force acts on the wire while it carries a current. Include what the class sees.

      3 marks
      Show the answer

      Answer: With the wire at rest in the gap, the teacher closes the switch so that a current flows. The wire jumps (swings) sideways, out of or into the gap. When the switch is opened, the wire falls back to where it was.

      Marking points

      • switch closed so that a current flows in the wire (in the field)
      • the wire moves / jumps / swings (sideways, into or out of the gap)
      • no current (switch open) means no movement / wire returns to rest
    2. (b)State two separate changes, each of which makes the wire move the opposite way.

      2 marks
      Show the answer

      Answer: Make the current flow the other way, by swapping over the leads at the supply. Or turn the magnet round so that N and S change sides, which reverses the field.

      Marking points

      • current flows the other way (supply leads swapped over)
      • field reversed (magnet turned round so that N and S change sides)
    3. (c)The teacher now makes both changes together. Explain why the wire moves the same way as it did at the start.

      2 marks
      Show the answer

      Answer: Each change on its own reverses the force. Two reversals cancel out, so the force points the original way.

      Marking points

      • each change alone reverses the force
      • reversing twice returns the force to its original direction
  3. 3.(Supplement) A straight wire lies in the gap between two magnetic poles, with N on the left of the gap and S on its right. In the wire, the current flows out of the page, towards the reader.

    1. (a)Name the rule that predicts which way the wire is pushed. State what the thumb and each of the two fingers stand for.

      4 marks
      Show the answer

      Answer: Fleming's left-hand rule. The thumb shows the force (motion), the first finger the magnetic field and the second finger the conventional current.

      Marking points

      • Fleming's left-hand rule
      • thumb: force / thrust / motion
      • first finger: (magnetic) field
      • second finger: (conventional) current
    2. (b)Determine which way the wire is pushed.

      1 mark
      Show the answer

      Answer: Upwards, towards the top of the page.

      Marking points

      • upwards (towards the top of the page)
    3. (c)The current is changed so that it flows into the page, and the magnet is replaced by a stronger one with the poles the same way round. State two ways in which the force changes.

      2 marks
      Show the answer

      Answer: It now points downwards, the opposite way, and it is bigger.

      Marking points

      • direction reverses / now downwards
      • the force is larger
  4. 4.(Supplement) In a vacuum tube, a beam of electrons travels horizontally from left to right. It enters a region where a uniform magnetic field points out of the page.

    1. (a)State the direction of the conventional current that the electron beam is equivalent to.

      1 mark
      Show the answer

      Answer: From right to left, the opposite way to the electrons.

      Marking points

      • right to left / opposite to the electrons' motion
    2. (b)Determine which way the electrons are pushed as they enter the field.

      1 mark
      Show the answer

      Answer: Upwards, towards the top of the page.

      Marking points

      • upwards (towards the top of the page)
    3. (c)Explain why the beam follows a curved path in the field.

      2 marks
      Show the answer

      Answer: The force always acts at right angles to the way the electrons are moving. It keeps changing their direction, so the path bends round into a curve.

      Marking points

      • force is (always) at right angles to the motion (velocity)
      • so the direction of motion keeps changing / the path bends
    4. (d)The electron beam is replaced by a beam of positively charged particles moving in the same direction. State how their deflection differs from that of the electrons.

      1 mark
      Show the answer

      Answer: They are deflected the opposite way, downwards.

      Marking points

      • opposite direction / downwards

Quick check

6 questions

  1. 1.A wire carrying a current between the poles of a magnet is pushed upwards. The current is reversed. What is the force on the wire now?
  2. 2.A wire in a magnetic field is pushed to the right. The current and the field are both reversed. Which way is the wire pushed now?
  3. 3.Which change makes the force on a current-carrying rod in a magnetic field larger?
  4. 4.(Supplement) In Fleming's left-hand rule, what does the first finger point along?
  5. 5.(Supplement) The N pole of a magnet is below a wire and the S pole above it. The current flows out of the page. Which way is the force on the wire?
  6. 6.(Supplement) A beam of protons and a beam of electrons travel in the same direction through the same magnetic field. How are they deflected?