Higher tier only: spec point 4.7.2.2
Only Higher tier papers test this, in both GCSE Physics and Combined Science. By the end, aim to:
- explain the motor effect, including the push on the magnet
- use Fleming's left-hand rule to find force, current or field from the other two
- name the three things the size of the force depends on
- apply , which is given on the equation sheet: select it rather than memorise it
Fields around current-carrying wires (4.7.2.1, both tiers) have their own page.
The motor effect
Every current sets up a magnetic field around its wire. Put that wire between two magnetic poles and the two fields interact, so the wire is shoved sideways: the motor effect. The magnet is shoved too, by a force just as big but pointing the other way, a Newton's third law pair.
The push is greatest when the wire crosses the field lines at right angles. Turn the wire until it lies along the field lines and the push vanishes.
Fleming's left-hand rule
On your left hand, hold the thumb, first finger and second finger at 90° to one another, like the edges at the corner of a box.
| Digit | Lines up with | Memory hook |
|---|---|---|
| First finger | the magnetic field, from N to S | First for Field |
| Second finger | the conventional current, from + to − | seCond for Current |
| Thumb | the force, which is the way the wire moves | Thumb for thrust |
Flip the current or the field and the force flips. Flip both and the force is back where it started.
Worked explanation: finding the direction
In a diagram, a magnet's N pole is at the left-hand side and its S pole at the right-hand side. A wire between them carries current into the page. Which way is it pushed?
- First finger: from N to S, so to the right.
- Second finger: into the page.
- Thumb: down the page. The wire is pushed downwards.
How big is the force?
Three quantities decide the size of the push:
- magnetic flux density , in tesla (T), a measure of field strength
- current , in amperes (A)
- length of conductor in the field , in metres (m)
When the wire is perpendicular to the field,
and comes out in newtons (N). Doubling any one quantity doubles the force. Use the equation only for a perpendicular wire: a wire parallel to the field feels no force, and AQA does not ask you to calculate the force at angles in between.
Worked example: a rod on rails
A copper rod lies across two metal rails, and 6.0 cm of it sits in a 0.35 T field, perpendicular to the rod. The rod carries 4.0 A. Find the force on it.
Given: T, A, cm m. Equation: . Substitution: . Answer: N (2 s.f.).
Rearranging: if a 0.15 m wire carrying 2.5 A feels a force of 0.045 N, then T.
Try the rule on screen
In the simulation above, the stage opens on Wire in a field: a 0.1 m rod carrying 2 A across a 0.5 T field, with N on the left. The current, labelled with a violet I, flows towards you, and the hand rule is already on show, its current arrow violet too.
- Force on the wire reads 0.1 N, since , and Direction of the force says upwards. Match the drawn hand with yours.
- Press Reverse I: the rod is pushed downwards and the hand turns over, but the size stays 0.1 N. Press Flip magnet as well, and the push is upwards again.
- Set Current to 4 A and the force becomes 0.2 N. Then halve Length of wire in the field to 0.05 m: back to 0.1 N.
- Use the Turn the wire to an angle toggle, then drag Angle between wire and field down to 0°. The force falls to 0 N. Working at other angles is tagged Beyond GCSE.