Skip to content

Cambridge IGCSE Physics (0625) · Magnetism and electromagnetic effects

Magnetic effect of a current

4.5.3

Core: field lines circle a current-carrying straight wire, and a solenoid's field looks like a bar magnet's outside; filings and compasses reveal both; relays and loudspeakers use the effect. Supplement: the field weakens away from a wire, and a larger or reversed current strengthens or reverses it.

Loading simulation…

Symbols match your course. Open the full magnetic field around a wire and solenoid simulation for more presets and teacher tools.

What this topic covers

In a Nairobi taxi, a small current through a relay connects the starter motor. Syllabus 4.5.3 explains how.

Round a straight wire (Core)

The lines are rings with the wire at their centre, in a plane perpendicular to the wire. Their direction follows the current's: aim your right thumb with the conventional current and your bent fingers give it (the right-hand grip rule). So ⊙ (current towards you) means anticlockwise, and ⊗ clockwise.

Inside and round a solenoid (Core)

Outside the coil the lines copy a bar magnet's pattern, leaving the N end and curving back to the S end. Inside, straight parallel lines carry them from S to N, so every line forms a loop. Quick test: look at one end; anticlockwise current means that end is N.

Finding the pattern (Core)

  1. Push the wire vertically through a horizontal card. For a solenoid, thread the coil through holes so the card lies along its axis.
  2. With a large current on, sprinkle iron filings and tap the card: they gather along the lines.
  3. Add plotting compasses: each needle's N end gives an arrow.
  4. Reverse the current: the needles swing round, but the filings stay put.

Strength and current (Supplement)

A straight wire's field is strongest close in and fades with distance, so the circles spread apart. A solenoid's is strong and almost uniform inside, where the lines are close, parallel and evenly spaced, and much weaker outside. More current strengthens the field everywhere (lines drawn closer); less weakens it. Reversing the current flips every arrow and swaps a solenoid's poles, but the pattern's shape never changes.

Relays (Core)

A relay is an electromagnet used as a switch: a small current in its coil, which has a soft iron core, controls a separate, large-current circuit in car starters or automatic street lamps.

Worked explanation: why soft iron?

  1. Current in the coil sets up a magnetic field, which magnetises the soft iron and makes the electromagnet far stronger.
  2. The electromagnet pulls the iron armature, which rocks on its pivot and closes the contacts: the large current flows.
  3. Stop the coil current and soft iron loses its magnetism at once; a spring then returns the armature and the contacts part.

Steel, by contrast, would remain a magnet and go on attracting the armature, so the contacts would stay shut.

Loudspeakers (Core)

A coil fixed to a light cone sits in a permanent magnet's field. An amplifier sends an alternating current through the coil, so the coil's field keeps changing size and direction. The two fields interact, so a changing force acts on the coil and drives the cone in and out in step with the current, making sound waves. Phones, headphones and radios all have one.

Simulation tasks

In the simulation above, the Straight wire set-up starts with a 5 A current coming up out of the card (⊙).

  1. (Core) Field lines go says Anticlockwise. Tap Reverse: all eight needles swing round and it says Clockwise. Tap Filings, then Reverse: the filings do not change. Tap Filings to clear them.
  2. (Supplement) Field at compass 1, 4 cm out, gives 25 μT. Drag Distance from the wire down to 2 cm: it doubles to 50 μT. Tap Less I three times (2 A): 20 μT, and just three circles.
  3. (Core) Pick Solenoid: N pole says Right-hand end, and the compass beyond it points away from the coil. Reverse gives Left-hand end. (Supplement) Set Current to 4 A: Field inside doubles from 4.05 mT to 8.09 mT. Return it to 2 A.
  4. (Core) Pick Relay and tap Switch: 0.05 A in the coil circuit pulls the armature, Contacts says Closed, and the motor circuit takes 6 A.
  5. (Core, 4.1) Pick Electromagnet, then Soft iron: 6 clips, which drop when you tap Switch. Tap it again, pick Steel, and set Current to 5 A and Turns to 400: 19 clips. Tap Switch: 5 stay, as steel makes a permanent magnet.

Values in teslas, Earth and Demagnetise go beyond 0625.

Common mistakes

  • Drawing a straight wire's field as lines along the wire, or as spokes coming out of it. The lines are rings round the wire, each lying flat in a plane perpendicular to it.
  • Giving the circles the wrong direction. With the right thumb along the conventional current, the bent fingers show the field's direction: ⊙ gives anticlockwise circles and ⊗ clockwise ones.
  • Claiming that iron filings show which way the field points. They give the pattern only, because no filing has a marked N end; plotting compasses add the arrows.
  • (Supplement) Drawing the circles round a wire evenly spaced. The field weakens further from the wire, so the gaps between circles should grow outwards.
  • Writing that a relay's coil is connected to the circuit it switches. The coil and the contacts have no electrical connection: the moving armature is the only link.
  • Choosing steel for a relay core. Steel stays magnetised once the current stops, so the armature would stay held down; soft iron loses its magnetism at once.

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A student in Lima investigates the magnetic field of a long straight wire. The wire runs straight down through a small hole in a flat, horizontal card and carries a large direct current.

    1. (a)Describe how the student uses iron filings to show the pattern of the field on the card.

      3 marks
      Show the answer

      Answer: Sprinkle a thin layer of iron filings over the card around the wire. With the current on, tap the card gently. The filings line up in circles centred on the wire.

      Marking points

      • sprinkle iron filings thinly on the card
      • tap the card gently (with the current switched on)
      • filings form circles (rings) centred on the wire
    2. (b)Describe how the student finds the direction of the field at a point on the card.

      2 marks
      Show the answer

      Answer: Put a plotting compass at the point. The N end of the needle points in the direction of the field there.

      Marking points

      • place a plotting compass at the point
      • the needle's N end gives the field direction
    3. (c)Seen from above, the current flows down into the card. State the direction of the field lines.

      1 mark
      Show the answer

      Answer: Clockwise, as seen from above.

      Marking points

      • clockwise (seen from above)
    4. (d)(Supplement) The current is first reduced and then reversed. Describe the effect of each change on the magnetic field.

      2 marks
      Show the answer

      Answer: A smaller current makes the field weaker at every point. Reversing the current reverses the field, so the lines now go anticlockwise as seen from above.

      Marking points

      • smaller current: weaker field (at every point)
      • reversed current: field direction reversed (anticlockwise seen from above)
  2. 2.A solenoid is connected to a d.c. supply. Looking at end X from outside the coil, the current flows clockwise around the turns. Y is the other end of the solenoid.

    1. (a)State which end of the solenoid behaves as a north pole.

      1 mark
      Show the answer

      Answer: Y.

      Marking points

      • Y
    2. (b)Describe the pattern of the magnetic field inside and outside the solenoid, including its direction.

      3 marks
      Show the answer

      Answer: Inside, the lines are straight and parallel. Outside, it looks like the field round a bar magnet. The lines leave end Y and curve round outside the coil to end X, then run back through the inside from X to Y.

      Marking points

      • inside: straight, parallel (evenly spaced) lines
      • outside: the shape of a bar magnet's field
      • direction: out of Y and into X outside the coil (X to Y inside)
    3. (c)(Supplement) State whether the field is stronger inside or outside the solenoid, and say what a diagram of the field lines shows to support this.

      2 marks
      Show the answer

      Answer: Inside. The field lines are closer together inside the coil than outside it.

      Marking points

      • inside (the solenoid)
      • the field lines are closer together there
    4. (d)(Supplement) The current is reversed. State the effect on the poles of the solenoid.

      1 mark
      Show the answer

      Answer: The poles swap: X becomes the north pole and Y the south pole.

      Marking points

      • the poles swap (X becomes N, Y becomes S)
  3. 3.A street lamp in Dubai is switched on by a relay. After dark, a light-sensing circuit passes a small current through the relay's coil, which is wound on a soft iron core. The relay then closes a separate circuit that supplies the lamp from the mains.

    1. (a)Describe how the relay switches the lamp on.

      4 marks
      Show the answer

      Answer: The current in the coil produces a magnetic field, which magnetises the soft iron core. The core attracts the iron armature, which pivots and pushes the contacts together. That completes the lamp's circuit, so a current flows and the lamp lights.

      Marking points

      • current in the coil produces a magnetic field (the core is magnetised)
      • the core pulls the (iron) armature towards it
      • the armature pivots and pushes the contacts together (closes the switch)
      • the lamp circuit is complete, so current flows in the lamp
    2. (b)Suggest why soft iron, rather than steel, is used for the relay's core.

      2 marks
      Show the answer

      Answer: Soft iron is a temporary magnet: once the coil current stops, its magnetism disappears, the armature springs back and the lamp goes off. A steel core would remain magnetised.

      Marking points

      • soft iron loses its magnetism when the coil current stops (temporary magnet)
      • so the armature is released and the lamp can go off (steel would stay magnetised)
    3. (c)Suggest one advantage of using a relay instead of passing the lamp's current through the light-sensing circuit.

      1 mark
      Show the answer

      Answer: The sensing circuit only has to carry a small current, so it can work at low voltage with thin wires and is kept separate from the mains.

      Marking points

      • the sensing circuit carries only a small current / is kept separate from the mains (safer)
  4. 4.A loudspeaker in a radio has a coil attached to a cone. The coil sits in the gap of a permanent magnet.

    1. (a)Explain how an alternating current in the coil makes the cone vibrate.

      3 marks
      Show the answer

      Answer: The current gives the coil a magnetic field of its own. This field interacts with the field of the permanent magnet, so a force acts on the coil. The current keeps changing direction, so the force does too, and the coil and cone are pushed backwards and forwards.

      Marking points

      • the current in the coil produces a magnetic field
      • this interacts with the permanent magnet's field, giving a force on the coil
      • the current (and so the force) keeps reversing, so the coil and cone move back and forth
    2. (b)State how the vibrating cone produces sound.

      1 mark
      Show the answer

      Answer: It makes the air in front of it vibrate, sending out sound waves.

      Marking points

      • it makes the air vibrate (sending out sound waves)
    3. (c)Name one other device that contains a loudspeaker.

      1 mark
      Show the answer

      Answer: Headphones (or a mobile phone, earphones or a television).

      Marking points

      • any one, e.g. headphones, mobile phone, earphones, television

Quick check

6 questions

  1. 1.Which statement describes the field lines of a current in a long straight wire?
  2. 2.In an experiment on the field of a wire, what does a plotting compass show that iron filings cannot?
  3. 3.(Supplement) How does the strength of the field round a straight wire change further from the wire?
  4. 4.(Supplement) The current in a solenoid is reversed but kept the same size. What happens to its magnetic field?
  5. 5.Why is the core of a relay's coil made of soft iron?
  6. 6.In a loudspeaker, what makes the coil and the cone move?