What AQA asks for (spec 4.5.5.1.1)
This page is GCSE Physics only: Combined Science papers do not include pressure in fluids. It is examined on both tiers. By the exam you need to:
- say what counts as a fluid
- explain that a fluid's pressure pushes on a surface at right angles to it, whichever way the surface faces
- recall and use . Learn it by heart, because the equation sheet does not include it.
Pressure at a depth in a liquid, and upthrust, come next in spec point 4.5.5.1.2, which is Higher tier only.
Liquids and gases are fluids
A fluid is a substance that can flow, so every liquid and every gas is one. A fluid takes the shape of its container and presses on every part of it that it touches.
A fluid's pressure always pushes normal to a surface, meaning at right angles to it. So the direction of the push depends on which way the surface faces:
| Surface touching the fluid | Direction of the push |
|---|---|
| Floor of a swimming pool | Straight down |
| Vertical wall of the pool | Sideways, into the wall |
| Sloping floor at the shallow end | At right angles to the slope, not straight down |
| Inside of a bicycle tyre | Outwards, at right angles to the rubber at every point |
| Flat bottom of a boat | Upwards |
Pierce a plastic bottle of water in a few places and watch: every stream leaves perpendicular to the plastic, then curves down under gravity.
The equation
is the pressure in pascals (Pa), is the force normal to the surface in newtons (N), and is the area of that surface in square metres (m²). A pascal is one newton on each square metre, so 1 Pa = 1 N/m². Fluid pressures often run into thousands of pascals, so kilopascals are common: 1 kPa = 1000 Pa. Rearranged, gives the force on a surface.
Worked example 1: an aquarium window. Sea water exerts an average pressure of 18 kPa on a viewing panel of area 2.5 m². Find the force of the water on the panel.
Given: kPa Pa, m². Equation: . Substitution: . Answer: N (45 kN), at right angles to the glass.
Worked example 2: a syringe. A nurse presses a syringe plunger with a force of 6.0 N. The plunger has an area of 1.5 cm². What pressure does it apply to the liquid?
Given: N, cm² m². Equation: . Substitution: . Answer: Pa, which is 40 kPa.
Why the simulation uses a solid
AQA introduces in its section on fluids, so expect it with liquids and gases. The equation itself works for any force spread over an area, and a solid block shows it clearly: put the same weight on a smaller face and the dent in the sand deepens. For a liquid pressing on a probe, try the simulation of liquid pressure and depth, which goes with the Higher tier equation .
Using the simulation
The simulation above opens with a 2.0 kg brick on its largest face in dry sand, and the pressure arrows switched on. Its Weight card shows 19.6 N. The Working lines convert the 200 cm² contact to 0.0200 m² and then divide, giving 980 Pa.
Predict the pressure with the brick standing upright, then choose End under the stage. The same 19.6 N now rests on 50 cm², a quarter of the area, so the pressure is four times bigger: 3920 Pa.
Next, pick Wood from Material, keep it on its end, and read the pressure: 980 Pa. This 0.50 kg block standing upright presses exactly as hard as the brick lying flat, because a quarter of the weight sits on a quarter of the area.
Last, switch What to explore to Everyday examples and pick the drawing pin. The thumb's 20 N push gives Pa where the head meets the thumb, but Pa at the point, whose area is ten thousand times smaller.