A tank, a probe and three jets
A tall glass tank holds a liquid, with a pressure probe hanging inside it on a thin rod. A rubber tube carries the pressure from the probe up to a dial gauge. Three holes in the right-hand wall stay plugged with rubber bungs until you press Play. A tap above the tank can keep the level steady while liquid pours out of the holes.
You choose the liquid, how deep it is, how tall a stand the tank sits on and where the probe is. The gauge, the readouts and the graph all respond straight away, even before the jets are running.
What the gauge measures
The gauge shows the extra pressure caused by the liquid above the probe. For a probe a depth h below the surface of a liquid of density ρ, where the gravitational field strength is g, that pressure is . With water, g = 9.8 N/kg and the probe 0.50 m down, the gauge reads 0.50 × 1000 × 9.8 = 4900 Pa.
Picture a slim column of liquid resting on a tiny patch of the probe. Lower the probe and the column above that patch gets taller and heavier, so it presses harder. Swap in a denser liquid and the same column carries more mass, so the pressure rises again. Your syllabus may write the same idea as p = ρgh, Δp = ρgΔh or P = ρgh.
The option for atmospheric pressure adds the push of the air on the surface, about Pa. It adds the same amount at every depth, so the total pressure grows by exactly as much as the gauge reading does.
A straight line through the origin
On the pressure against depth graph, each liquid gives a straight line that starts at zero. Pressure is proportional to depth. Drag along a line with the gradient tool and you will find its gradient is ρg: about 9800 Pa for every metre of water, and 13.6 times that for mercury. A teacher can hide the density, leaving you to work it out from the gradient.
Equal in every direction, whatever the shape
The eight arrows round the probe always match in length. At a point in a liquid that is not flowing, pressure acts equally upwards, downwards and sideways.
The connected vessels below the stage make a second point. A wide tank, a funnel, a thin tube and a sloping tube are joined at the bottom. The liquid settles at one level in all four, and at the probe's depth the pressure is identical in each one. The vertical depth below the surface is all that matters. The funnel holds far more liquid than the thin tube, but its sloping walls carry much of that weight.
Extension: how fast, and how far?
Every jet leaves the wall at right angles, which is the sideways push made visible. Deeper holes give faster jets. With no friction, the speed is , where d is the depth of the hole below the surface. This result goes beyond most courses for ages 14 to 16. Density cancels out of it, so mercury and water jets from the same depth leave equally fast.
Outside the tank, each jet is a projectile. It keeps its sideways speed while it drops the height H to the tray, landing at . With the tank full and standing in the tray, the bottom jet is quickest but has the shortest fall, so the middle jet reaches furthest. Put the tank on a 0.6 m stand, or keep it in the tray with the liquid less than 0.7 m deep, and the bottom jet takes the lead. That is why the speed of a jet, rather than where it lands, is the fair test of pressure.
Switch the tap off and the level drops as the tank empties. Every jet slows and shortens, and the top hole is the first to run dry.