What you need for 4.2.4.2
This spec point is on both tiers, for GCSE Physics and for Combined Science. It is about what appliances are for: moving energy from a supply into the store where it is useful. Expect questions that ask you to:
- say where an appliance gets its energy (a battery or the mains) and which store it fills, for motors and for heaters
- find the energy transferred from the power and the running time, or from the charge and the p.d.
- use power ratings to compare how quickly appliances change energy stores
Both equations must be recalled, because the equation sheet leaves them out.
Following the energy
A current flowing through an appliance means electrical work is being done: energy is moving from the supply into the appliance. It may start in the chemical store of a battery, or arrive from a power station through the a.c. mains.
| Appliance | Supply | Useful store that increases |
|---|---|---|
| electric toothbrush | rechargeable battery | kinetic store of the motor and brush head |
| kettle | mains | thermal store of the heating element, then of the water |
| hair dryer | mains | kinetic store of the fan, and thermal store of the heater and the air blown out |
No appliance puts all of its energy where we want it. Motors get warm and make a noise, and a kettle warms the kitchen as well as the water. This wasted energy is dissipated: the surroundings gain it as thermal energy.
Energy from power and time
Measure the energy in joules (J), the power in watts (W) and the time in seconds (s). Double the power, or the time, and the energy doubles.
Worked example 1. A 2.2 kW kettle is switched on for 3 minutes 30 seconds. How much energy does it transfer?
Given: W, s
Equation:
Substitution:
Answer: J, about 460 kJ to 2 significant figures.
Energy from charge and p.d.
Each coulomb moving through a p.d. of volts transfers joules. For a charge flow , in coulombs (C), the total is
Worked example 2. A cordless drill runs from an 18 V battery. Its motor takes a steady current of 3.0 A for 5.0 minutes. Calculate the energy transferred.
Given: A, s, V
Step 1, the charge: C
Step 2, the energy:
Answer: J, about 16 kJ to 2 significant figures.
As a check, W, and J again.
Power ratings and stored energy
A power rating is the number of joules an appliance transfers each second in normal use, so a higher rating changes the energy stores faster. In the same hour, a 2 kW fan heater transfers 200 times as much energy as a 10 W LED lamp. If no energy were wasted, a 3.0 kW kettle would raise the thermal store of a litre of water by as much in 1 minute as a 1.5 kW travel kettle does in 2 minutes.
Explore it: following each joule
In the simulation above, press Play and let the stopwatch run until it stops at 30 s. Each 1 C bunch leaves the battery labelled 6 J and is down to 0 J after the lamp. The Energy transferred card ends at 360 J, which the Working box reaches by two routes: (60.0 C × 6 V) and (12.0 W × 30.0 s).
Now choose Motor on 6 V from the Examples menu and read the note under the cards: most of the energy goes to the kinetic store of the fan, and a smaller part heats the coil. With 12 V, 36 W heater, the note says that all of it heats the heater and then the surroundings.
Finally, press Appliances, pick Kettle for 15 minutes (a typical 2.5 kW rating) from the Examples menu and press Play. Under its kWh value, the Energy card shows 2.25 MJ: check it with 2500 W × 900 s. The Working lines in this view are tagged "not in AQA GCSE", so treat the kWh and the cost as extra.