What this simulation shows
A block measuring 20 cm × 10 cm × 5 cm sits in a glass-fronted tank of dry sand or soft foam. It has three different faces it can rest on: the large one (200 cm²), a long narrow one (100 cm²) and an end (50 cm²). Press a face button and the block lifts out, turns over in the air and lands on the spot kept for that face, so you can see every dent side by side. The glass cuts the sand open along the front of the block, so each dent shows in cross-section.
One weight, three pressures
Whichever way up it lands, the block pushes down on the sand with its whole weight. Turning it over cannot change that number. What does change is how much sand shares the load. Pressure measures exactly this: the force on each square metre of surface.
Here is the force at right angles to the surface in newtons and is the contact area in square metres, giving the pressure in pascals. With the end down, the area is a quarter of the flat face, so the pressure is four times bigger and the block sinks further. A warm glow under the contact gets brighter as the pressure rises, and the pressure arrows show the push on each square centimetre.
The force matters too
Change the material and the size stays fixed while the weight changes. A wooden block of 0.50 kg, a brick of 2.0 kg and a steel block of 7.9 kg all have the same faces, so for any one face the pressure rises in step with the weight. Notice that the steel block lying flat and the brick on its end give almost matching pressures.
Getting the units right
Most mistakes in pressure questions come from areas.
| Area | In m² | Why |
|---|---|---|
| 1 cm² | 0.0001 m² | 1 m² is 100 cm × 100 cm = 10 000 cm² |
| 1 mm² | 0.000001 m² | 1 m² is 1000 mm × 1000 mm = 1 000 000 mm² |
| 200 cm² | 0.0200 m² | 200 ÷ 10 000 |
Weight must be in newtons, so a mass in kilograms is multiplied by before you divide by the area.
Everyday examples
The second part of the simulation sets a small and a large contact area next to each other under the same force: the sharp edge and the back of a knife blade, the point and the head of a pin, a stiletto heel and a flat heel, boots and snowshoes on snow, and a balloon resting on a single nail or on a bed of 400. Wide tractor tyres and broad camel feet work in the same way as snowshoes. A scale under the panels runs in powers of ten, because these pressures differ by up to ten thousand times.
About the model
The forces and areas are typical example values. How far anything sinks or cuts in is a simple model: on the same material, more pressure always means further in, but not in proportion. Four times the pressure does not make a dent four times as deep, and real sand, foam and snow behave in more complicated ways, so compare depths, but do not measure them.
In your course
Cambridge IGCSE defines pressure as force per unit area in its Core content, expects you to recall , and asks for everyday examples like these. The Punjab Physics 9 book writes with units of N m⁻², or pascals. AQA GCSE has no separate topic on solids: appears in the physics-only section on pressure in fluids, but the equation and the units are identical. It is one of the equations AQA expects you to recall, so it is not on the equation sheet.