A rod that jumps out of a magnet
The first set-up hangs a short copper rod from two thin leads, so that it sits in the gap of a U-shaped magnet. The N pole is painted red and the S pole blue, and the field lines run straight across the gap from N to S. When current flows, glowing dots drift round the circuit and the rod kicks up or down, then settles. A large orange arrow shows the force on it. Change the flux density, the current or the length of rod inside the field, and the arrow, the jump and the Force on the wire card all respond at once.
Working out the size of the force
For a wire at right angles to a field, the force is
where is the magnetic flux density in tesla, is the current in amperes and is the length of wire inside the field, in metres. The default settings give N. Doubling any one of the three doubles the force, while halving two of them cuts it to a quarter. Some courses write the length as a lower-case l, and the working box under the stage follows whichever course you pick.
Which way is it pushed?
Swap the supply connections with Reverse I, or turn the magnet round with Flip magnet, and the force reverses. Do both and it points the original way again. Fleming's left-hand rule predicts the direction. Hold your thumb, first finger and second finger at right angles, point the first finger along the field and the second along the conventional current, and the thumb shows the push. The illustrated hand in the corner of the stage turns to match every change, so you can check your own hand against it.
The rule only works when the current and the field are at right angles. Switch on Turn the wire to an angle and swing the rod round. The force shrinks as the rod lines up with the field and vanishes when it lies along the field lines. At other angles its size is , which goes beyond most GCSE courses.
From a single wire to a motor
Choose d.c. motor and the gap holds a rectangular coil on an axle instead. Current flows along one long side and back along the other, so one side is pushed up while the other is pushed down, and together they turn the coil. While current flows, these two forces keep the same size all the way round. What changes is how far apart their lines of action are: widest with the coil horizontal, where the turning effect is biggest, and zero with the coil vertical, when both forces line up with the axle. The graph under the stage plots this as the coil goes round.
The job of the split ring
Left to itself, the coil would rock to a stop in the vertical position. A split-ring commutator prevents this. Its two copper halves turn with the coil, and the carbon brushes pass from one half to the other just as the coil reaches the vertical, which reverses the current. The side that has just moved across to the right is then pushed the same way as the side that was there before. Use Slow-mo to catch the sparks at the brushes as the current switches over, then choose Slip rings to see what happens without a split ring.
More current, more turns of wire or a stronger field all give a bigger turning effect, so the model motor spins faster. Its friction is chosen so that you can follow the coil by eye: a real motor would turn far more quickly.