What this topic covers
Every living tree, from the Amazon to Borneo, holds a little carbon-14, and each of those nuclei will become nitrogen at a moment nobody can foresee. This page (syllabus 5.2.3) shows what changes inside a decaying nucleus, and how to write it as an equation. Half-life (5.2.4) and the emissions themselves (5.2.2) are covered separately.
A change inside the nucleus (Core)
An unstable nucleus has a mix of protons and neutrons that cannot last. Sooner or later it changes: that is radioactive decay. Out comes an alpha or a beta particle, often with gamma radiation; some nuclei, such as technetium-99m, give out gamma alone.
Decay is spontaneous: it starts by itself, and heating, compressing or reacting the material cannot hurry it or delay it. It is also random: nobody can say which nucleus will change next, or when.
A new element (Core)
The proton number fixes the element. Alpha decay removes two protons and beta decay adds one, so the nucleus left is of a different element: carbon-14 becomes nitrogen-14, and americium-241 becomes neptunium-237. Gamma emission changes neither the proton number nor the nucleon number, so the element stays the same.
Why some nuclei are unstable (Supplement)
- Too many neutrons. Carbon-14 has 8 neutrons with its 6 protons, two more than stable carbon-12. Nuclei with surplus neutrons usually decay by beta emission.
- Too heavy. Very large nuclei, such as uranium-238 and americium-241, carry more nucleons than can stay bound for good. They usually emit alpha particles.
How each emission changes the nucleus (Supplement)
| Emission | What happens in the nucleus | Nucleon number A | Proton number Z |
|---|---|---|---|
| Alpha (α) | 2 protons and 2 neutrons leave together, so a heavy nucleus gets lighter | down 4 | down 2 |
| Beta (β) | neutron → proton + electron; the electron is shot out, leaving fewer surplus neutrons | no change | up 1 |
| Gamma (γ) | spare energy leaves as electromagnetic radiation, and the nucleus settles into a lower-energy state | no change | no change |
Each emission leaves the nucleus more stable, though it may still be unstable and decay again.
Writing decay equations (Supplement)
In nuclide notation an alpha particle is and a beta particle is ; you may also see and . Gamma is written γ and adds nothing to either total. The top numbers (nucleon numbers) must have equal totals on each side, and so must the bottom numbers (proton numbers).
Worked example. Iodine-131, , emits a beta particle, followed by a gamma ray. Find the new nucleus; the element with proton number 54 is xenon, Xe.
- Nucleon number: a beta particle carries no nucleons, so A stays 131.
- Proton number: one neutron becomes a proton, so Z = 53 + 1 = 54, which is xenon.
- Equation:
- Check: top, 131 = 131 + 0; bottom, 53 = 54 + (−1).
Answer: xenon-131, .
For an alpha emitter, take 4 from the top and 2 from the bottom: .
Decays you can watch
In the simulation above, the panel under Isotope shows the Decay equation. Its note uses the other names, mass and atomic numbers. Changing the isotope restarts the run, paused.
- (Core) The run opens on Protactinium-234m, a beta emitter that becomes uranium-234 (the m marks a nucleus with extra energy). Press Play. Each dot that dims is now uranium, counted on the Decayed card; it stays in the tray, so nothing is removed.
- (Core) Press New sample, which resets and pauses the run, then Play. Different nuclei go first, with no warning. Reset would replay one sample exactly.
- (Supplement) Choose Americium-241 and check its alpha equation: 241 = 237 + 4 and 95 = 93 + 2.
- (Supplement) Choose Cobalt-60: its beta decay is followed by gamma, so the equation ends in γ. Then choose Technetium-99m, which gives out gamma alone: the Decayed card reads "now technetium-99", the same element.
To practise writing decay equations yourself (Supplement), try the nuclear equations simulation: you choose the emission and set the new nucleus, and both rows must balance.