Skip to content

Cambridge IGCSE Physics (0625) · Nuclear physics

Half-life

5.2.4

Core: an isotope's half-life is the time after which only half of the nuclei in a sample remain undecayed; use it with tables and decay curves. Supplement: remove background before finding a half-life, and choose isotopes for jobs from the radiation they emit and their half-life.

Loading simulation…

Symbols match your course. Open the full radioactive decay and half-life simulation for more presets and teacher tools.

What this topic covers

Half the technetium-99m in a Santiago hospital bone scan decays in about 6 hours; half the americium-241 in a smoke alarm takes about 430 years. This page (syllabus 5.2.4) explains half-life, its calculations and how it helps decide which isotope to use. Decay itself is covered in 5.2.3.

Count rates are in counts/s or counts/minute (5.2.1); activity and becquerels are beyond this syllabus.

What half-life means (Core)

Start a clock with any sample of one isotope. The half-life is the time on the clock when half of those nuclei have decayed. Each later half-life halves what is left: 6400, 3200, 1600, 800 undecayed nuclei. A full definition carries five ideas: a time, half, the nuclei of that isotope, any sample, and decay.

Amount, temperature and chemical form make no difference to it. The count rate halves in the same time, which is how half-lives are measured.

Worked example: a Core calculation

Given: a sample holds 6.4×1066.4 \times 10^6 undecayed nuclei of an isotope whose half-life is 2.5 days. Find how many are left after 10 days.

  1. Number of half-lives: 10÷2.5=410 \div 2.5 = 4.
  2. Four halvings divide by 24=162^4 = 16: 6.4×106÷16=4.0×1056.4 \times 10^6 \div 16 = 4.0 \times 10^5.
  3. Fraction left: 1/16 = 0.0625.

Answer: 4.0×1054.0 \times 10^5 undecayed nuclei.

On a decay curve, read across from half the starting count rate, then down.

When background is included (Supplement)

Background adds the same amount to every reading and never decays, so a measured curve levels off at the background count rate. Subtract it from every value before halving.

Given: a measured decay curve flattens out at 0.5 counts/s. It reads 6.5 counts/s at the start, 3.5 counts/s at 40 s and 2.0 counts/s at 80 s.

  1. Background: 0.5 counts/s, where the curve flattens.
  2. Corrected count rates: 6.0, 3.0 and 1.5 counts/s, halving every 40 s.

Answer: half-life = 40 s. Halving the measured 6.5 counts/s instead gives 3.25 counts/s, not reached until about 45 s: too long.

Choosing an isotope (Supplement)

The radiation must reach its target; the half-life must suit the job's length.

JobRadiationHalf-life
Smoke alarm (americium-241)Alpha: strongly ionising, yet too short-ranged to escape the caseAbout 430 years: steady for the alarm's life
Irradiating food, sterilising equipment (cobalt-60)Gamma: passes through packaging to kill bacteria, leaving nothing radioactiveAbout 5.3 years: years of use between replacements
Gauging paper or thin sheets (strontium-90)Beta: partly absorbed, so the count rate tracks the thickness (alpha would all be stopped; gamma suits thick steel)About 29 years: count changes come from the sheet, not the source
Diagnosing cancer as a tracer (technetium-99m)Gamma: leaves the body to reach a camera, ionising littleAbout 6 hours: lasts the scan, then soon dies away
Treating cancer with beams (cobalt-60)Gamma: penetrating beams from several directions meet at the tumourAbout 5.3 years: one source lasts for years

These are the usual textbook choices, and real practice varies. Many hospitals now aim X-ray beams from machines at tumours instead of cobalt-60, and some food and equipment is sterilised with electron beams. In an exam, justify each choice from its radiation and its half-life, as the table does.

Trying it yourself

In the simulation above, choose Radon-220 under Isotope; the run restarts, paused.

  1. (Core) Press Play. Text under the graph gives the time when half of the 400 nuclei had decayed: about 56 s, against the Half-life T½ card's 55.6 s.
  2. (Core) After the run, press ⅛ under Half-life line at: about 157 s, three halvings of about 52 s. Press Reset, choose 3 under Pause after, then Play. When it stops, compare This sample with Expected N (50).
  3. (Supplement) Set Pause after to Off. Then choose 1600 under Nuclei at the start and set Background count rate to 1.0 counts/s; each of these two changes restarts the run, paused. (400 nuclei give only about 1 count/s from the source.) Switch the graph to Count rate and press Play. When the run is over, the corrected count rate takes about 57 s to halve; switch off Subtract the background and the recorded readings take about 76 s.
  4. (Supplement) Under Choose an isotope for the job, select Paper gauge, try each isotope, then press Show the usual choice.

Common mistakes

  • Dividing by the number of half-lives. Each half-life halves the amount again, so after 3 half-lives 1/8 (0.125) of the nuclei are undecayed, not 1/3.
  • Describing the half-life as half the time a sample takes to decay completely. A sample never reaches zero at a definite time; each half-life only halves what remains.
  • (Supplement) Halving readings that still include background. Background adds the same amount to every reading and does not decay, so the half-life comes out too long unless it is subtracted first.
  • Thinking a smaller, older or cooler sample has a shorter half-life. Every sample of an isotope has the same half-life, whatever its size, age or temperature.
  • (Supplement) Picking an alpha emitter as a medical tracer, or a gamma source to gauge paper. Alpha cannot get out of the body, and gamma passes through paper almost unchanged.
  • (Supplement) Assuming the longest half-life is always best. A tracer needs a short one, so the patient stops being exposed soon after the scan.

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A radioactive isotope has a half-life of 3.0 hours. At noon a sample contains 8.0 × 10⁶ undecayed nuclei of the isotope.

    1. (a)State what is meant by the half-life of an isotope.

      1 mark
      Show the answer

      Answer: How long it takes until only half of the original nuclei of that isotope remain undecayed.

      Marking points

      • time until half of the nuclei (of that isotope) have decayed
    2. (b)Calculate the number of undecayed nuclei at 9 p.m.

      2 marks
      Show the answer

      Answer: 9 hours is 3 half-lives, so 8.0 × 10⁶ ÷ 8 = 1.0 × 10⁶ nuclei.

      Marking points

      • 3 half-lives
      • 1.0 × 10⁶
    3. (c)Calculate how many hours after noon only 2.5 × 10⁵ nuclei remain undecayed.

      2 marks
      Show the answer

      Answer: 8.0 × 10⁶ ÷ 2.5 × 10⁵ = 32, which is 5 halvings. 5 × 3.0 = 15 hours.

      Marking points

      • 5 half-lives
      • 15 hours
    4. (d)State the fraction of the original nuclei that have decayed by 9 p.m. Give your answer as a decimal.

      1 mark
      Show the answer

      Answer: 1 − 0.125 = 0.875

      Marking points

      • 0.875
  2. 2.A detector is placed next to a radioactive sample. The background radiation is too small to matter. The count rate is recorded every 3 minutes: 960 counts/min at 0 min, 679 at 3 min, 480 at 6 min, 339 at 9 min, 240 at 12 min and 170 at 15 min.

    1. (a)Determine the half-life from these readings.

      2 marks
      Show the answer

      Answer: The count rate falls from 960 to 480 counts/min in 6 min, and from 480 to 240 counts/min in the next 6 min. Half-life = 6 min.

      Marking points

      • halving read from the data, e.g. 960 to 480 counts/min
      • 6 min
    2. (b)Predict the count rate at 24 min.

      2 marks
      Show the answer

      Answer: 24 min is 4 half-lives, so 960 ÷ 16 = 60 counts/min.

      Marking points

      • 4 half-lives
      • 60 counts/min
    3. (c)The readings are repeated with the same sample, and they differ slightly from the first set. Suggest why.

      1 mark
      Show the answer

      Answer: Decay is random: how many nuclei decay in each interval varies by chance.

      Marking points

      • decay is random
  3. 3.A student measures the background count rate as 15 counts/min. The student then records the count rate near a radioactive source without subtracting the background: 655 counts/min at 0 min, 335 at 12 min, 175 at 24 min and 95 at 36 min.

    1. (a)(Supplement) Calculate the corrected count rates at 0 min and at 12 min.

      2 marks
      Show the answer

      Answer: 655 − 15 = 640 counts/min and 335 − 15 = 320 counts/min.

      Marking points

      • 640 counts/min
      • 320 counts/min
    2. (b)(Supplement) Determine the half-life of the source.

      2 marks
      Show the answer

      Answer: The corrected count rate halves from 640 to 320 counts/min in 12 min (and again to 160 counts/min by 24 min). Half-life = 12 min.

      Marking points

      • corrected rate halves (640 to 320 counts/min)
      • 12 min
    3. (c)(Supplement) Explain why the background must be subtracted before the half-life is found.

      2 marks
      Show the answer

      Answer: Background is part of every reading and stays the same because it does not come from the decaying source. Halving the measured readings would therefore give a half-life that is too long.

      Marking points

      • background is in every reading and does not decay (stays constant)
      • measured readings take longer to halve, so the half-life found would be too long
    4. (d)(Supplement) Predict the count rate the student would record at 48 min.

      2 marks
      Show the answer

      Answer: 48 min is 4 half-lives, so the corrected rate is 640 ÷ 16 = 40 counts/min. Adding the background gives 40 + 15 = 55 counts/min.

      Marking points

      • corrected rate of 40 counts/min
      • 55 counts/min (background added back)
  4. 4.Four radioactive isotopes are available. J emits alpha particles and has a half-life of 430 years. K emits beta particles and has a half-life of 29 years. L emits gamma rays and has a half-life of 5.3 years. M emits gamma rays and has a half-life of 6 hours.

    1. (a)(Supplement) State which isotope should be used in a household smoke alarm, and explain your choice.

      3 marks
      Show the answer

      Answer: J. Its alpha particles ionise the air inside the alarm strongly, but their short range means they do not escape from it. Its long half-life means the source does not need replacing during the life of the alarm.

      Marking points

      • J
      • alpha is strongly ionising and has a short range (stays inside the alarm)
      • long half-life, so the source lasts the life of the alarm
    2. (b)(Supplement) A paper mill uses isotope K to control the thickness of its paper. Explain why beta particles are suitable for this.

      2 marks
      Show the answer

      Answer: Paper absorbs some of the beta particles, and a thicker sheet absorbs more, so the count rate changes clearly with thickness. Alpha particles would all be absorbed, and gamma rays would pass through almost unaffected.

      Marking points

      • beta is partly absorbed by paper
      • so the count rate changes with thickness (alpha all absorbed / gamma hardly affected)
    3. (c)(Supplement) Explain why isotope M, not isotope L, is used as a tracer to help diagnose cancer.

      2 marks
      Show the answer

      Answer: Both emit gamma rays, which can leave the body and be detected. M's half-life of 6 hours lasts long enough for the scan, but the radiation then dies away quickly; L would keep exposing the patient for years.

      Marking points

      • M's short half-life lasts the scan but then the count rate falls quickly
      • L's long half-life would expose the patient for years
    4. (d)(Supplement) Suggest why isotope L is suitable for sterilising medical equipment that is sealed in plastic bags.

      2 marks
      Show the answer

      Answer: Its gamma rays pass through the plastic and kill the bacteria inside. Its half-life of 5.3 years means the source keeps working for years without needing to be replaced often.

      Marking points

      • gamma penetrates the packaging to kill bacteria
      • long half-life, so the source lasts for years

Quick check

6 questions

  1. 1.A sample contains 4800 undecayed nuclei. The half-life is 20 minutes. How many nuclei are undecayed after 1 hour?
  2. 2.A sample's count rate drops from 512 to 64 counts/s in 18 hours. What is the half-life?
  3. 3.Which statement about the half-life of an isotope is correct?
  4. 4.(Supplement) Measured count rates include a background of 10 counts/min. A reading of 330 counts/min falls to 170 counts/min in 15 minutes. What is the half-life?
  5. 5.(Supplement) Why is a medical tracer chosen to have a half-life of only a few hours?
  6. 6.(Supplement) Which source is best for a gauge that controls the thickness of paper?