Light changes direction at a boundary
Shine a narrow beam of light from air into a glass block at an angle and it bends where it crosses the surface. This bending is refraction. The cause is a change of speed: light moves more slowly in glass, water or Perspex than it does in air. Describing what the ray does is Core. Putting numbers on it is Supplement.
Three terms you must use correctly (Core)
- The normal is a construction line drawn at 90° to the boundary, at the point where the ray meets it.
- The angle of incidence, , is measured between the normal and the ray arriving at the boundary.
- The angle of refraction, , is measured between the normal and the ray after it has crossed the boundary.
Both angles are measured from the normal, never from the surface of the block. Measuring from the surface is a classic way to lose marks.
What happens to the ray at a boundary (Core)
- Light entering a medium where it travels more slowly, such as air into glass, bends towards the normal, so is smaller than .
- Light entering a medium where it travels faster, such as water into air, bends away from the normal.
- Light arriving along the normal goes straight on without bending, even though its speed still changes.
Some light is also reflected at the boundary, giving a faint reflected ray.
For a rectangular block, the ray bends towards the normal as it goes in and away from the normal as it comes out. Because the two long faces are parallel, the ray leaves travelling in its original direction, just shifted sideways.
Refraction is why a pool seems less deep than it is, and why a pencil dipped into a beaker of water appears broken where it enters the water.
The block experiment (Core)
Cambridge expects you to describe an experiment showing refraction by blocks of different shapes, such as a rectangular block, a semicircular block and a triangular prism. In outline: place the block on paper and draw round it; send a thin ray from a ray box into one face; mark the path of the ray going in and coming out with crosses spaced well apart; take the block away and join the marks to show the ray inside the glass. Draw the normal where the ray enters and measure both angles with a protractor. Repeat for other angles and other shapes.
Practise every step, with a results table, in the virtual practical.
Worked example (Supplement)
A ray passes from air into a glass block. The angle of incidence is 40° and the angle of refraction is 25°. Find the refractive index of the glass and the speed of light inside it.
Given: , , m/s.
Equation and substitution:
Then rearrange to find the speed in the glass:
Answer: (no unit), and light travels at about m/s in this glass.
Try it in the refraction simulation
In the simulation above, choose air for "Light starts in" and glass for "Light goes into". Drag the ray box from 0° up towards 80° and watch the refracted ray always sit closer to the normal than the incident ray. Now change glass to water: at the same angle of incidence the ray bends less, because water slows light less than glass does. Extended candidates can check their own calculations against the Snell check and the speed readout.