What this topic covers
The normal and the two angles (Core)
Where a ray lands on a mirror, draw a dashed line at right angles (90°) to the mirror. This is the normal: a line to measure angles from, not a ray of light.
- Angle of incidence, : from the normal round to the incoming ray.
- Angle of reflection, : from the normal round to the outgoing ray.
The angle between a ray and the mirror's surface is , which differs from unless both are 45°.
The law of reflection (Core)
The reflected ray leaves on the other side of the normal. A ray sent in along the normal has , so : it returns straight back along its own path.
Worked example 1 (Core)
In a school lab in Nairobi, a laser beam hits a plane mirror at 27° to its surface. Find , , and how many degrees separate the incoming and reflected beams.
Step 1: switch to the normal. The normal meets the mirror at a right angle, so
Step 2: use the law. .
Step 3: add. The beams are on opposite sides of the normal: .
Answer: , and the beams are 126° apart. Giving 27° for is the classic slip.
The image in a plane mirror (Core)
Rays spread out from each point on an object. After reflecting off the mirror they are still spreading out, and some enter your eye. Your brain assumes that light moves in straight lines, so it follows these rays straight back. Behind the mirror, the traced-back lines all meet at one point: the image of that point. Learn three facts:
- Same size as the object.
- Same distance: the image's distance behind the mirror equals the object's distance in front, both measured along the line through the object at 90° to the mirror. The mirror sits halfway between them.
- Virtual: no reflected light goes behind the mirror. The rays merely look as if they started at the image, so a screen placed there shows nothing.
The image is also upright. Moving your head changes which rays you catch, not where the image is.
Worked example 2: locating an image (Supplement)
On a scale drawing, a point object O is 3.0 cm in front of a plane mirror. Find its image.
- From O, draw a line meeting the mirror at 90°, at N. A ray along ON has and reflects back along itself, so the image lies on ON continued behind the mirror (dashed).
- Draw a second ray from O to the mirror at A, 4.0 cm from N. Add a dashed normal at A.
- Measure (about 53°) and draw the reflected ray from A on the other side of the normal, so that .
- Continue that reflected ray back behind the mirror as a dashed line. It crosses the continuation of ON at the image, I.
- Measure: NI = 3.0 cm, equal to ON.
Calculation: O and I are cm apart. Move O 1.0 cm closer to the mirror and I also moves 1.0 cm closer, so the gap becomes 4.0 cm.
Using the mirror simulation (Core and Supplement)
In the simulation above, Ray mode opens with an Angle of incidence of 40°, and the Angle of reflection card also reads 40°.
- Drag the ray box, or use the Angle of incidence slider, to reach 63°: both angle cards read 63° and Angle between the rays reads 126°. Switch on Trap: angle to the mirror to see the 27° that is not .
- Pick Along the normal from Set-ups: the ray comes straight back.
- Press Image. Pin to mirror and Mirror to image both read 12 cm. Switch on Screen at the image: nothing forms on it. Drag the eye, or use the Eye height slider: the image stays put.
- Supplement: set Pin distance from the mirror to 9 cm. The image is now 9 cm behind, so pin and image are 18 cm apart.
Beyond IGCSE: the Turn the mirror slider, Periscope, Surfaces, and the "Laterally inverted" note under the Image readouts (left and right look swapped; strictly, the mirror reverses front and back).