Skip to content

Virtual practical

Refraction Through a Glass Block

Shine a ray into a glass block, measure the angle of refraction for different angles of incidence, then use a graph of sin i against sin r to find the refractive index of the glass.

GCSE AQA: Required practical 9 (refraction) — physics onlyCambridge IGCSE: Syllabus experiment (Core)
Loading simulation…

Aim

To investigate how the angle of refraction depends on the angle of incidence when light enters a glass block, and to find the refractive index of the glass.

Equipment

  • ray box with a single-slit filter and power supply
  • rectangular glass block
  • protractor, ruler and sharp pencil
  • sheet of white A3 paper

Variables

TypeVariable
IndependentAngle of incidence, i
DependentAngle of refraction, r
ControlThe same glass block, the same colour of light, a narrow ray, the same face of the block

Method

  1. Put the block on the paper and draw around it with a sharp pencil.
  2. Remove the block. Draw a normal at 90° to one long side, near the middle.
  3. Use the protractor to draw lines at 20°, 30°, 40°, 50°, 60° and 70° to the normal. These are the incident rays.
  4. Put the block back on its outline. Shine the ray along the first incident line so it meets the block where the normal touches it.
  5. Mark the point where the ray leaves the far side of the block with a small cross.
  6. Remove the block and join the entry point to the exit cross. This line shows the refracted ray inside the glass.
  7. Measure the angle between this line and the normal. This is the angle of refraction.
  8. Repeat for each angle of incidence. Repeat the whole set twice more and calculate a mean for each angle.

In the virtual version above, each press of Measure gives one protractor reading, with the small random errors a real student makes.

Risk assessment

HazardRiskControl
Ray box gets hotBurns to fingersLet it cool before moving it; hold it by the base
Glass blockCuts if chipped or droppedCheck edges before use; keep it away from the bench edge
Dim roomTripping over bagsClear the floor before turning off the lights

Analysing the results

Plot sin i on the y-axis against sin r on the x-axis. The points should lie close to a straight line through the origin, which shows that sin i is proportional to sin r. The gradient of the line is the refractive index:

n=sin⁡isin⁡rn = \frac{\sin i}{\sin r}

Most glass gives a value close to 1.5. The virtual lab works out the gradient with a line of best fit and estimates the uncertainty from the spread of your results.

Evaluation

Sources of error. A wide ray makes it hard to see exactly where it enters and leaves the block. Pencil lines have a thickness, so angles can be misread by about a degree. If the block moves on the paper, the outline no longer matches the block.

Improvements. Use a narrower slit for a thinner ray. Mark the ray with two crosses as far apart as possible before joining them. Draw the outline again if the block moves. Repeat readings and take a mean to reduce the effect of random errors.

Why plot a graph? A single calculation uses one pair of readings, so one bad reading changes the answer. The gradient of a best-fit line uses every reading, so random errors partly cancel out.

Exam-style questions

1. A student measures an angle of refraction of 25° for an angle of incidence of 40°. Calculate the refractive index of the block. (2 marks)

2. Explain why the student should repeat each reading and calculate a mean. (2 marks)

3. The student's graph of sin i against sin r is a straight line, but it does not pass through the origin. Suggest a reason. (1 mark)