What this topic covers
Hang masses on a spring and it stretches. A load–extension graph shows by how much, and where that pattern changes.
Stretching a spring (Core)
Forces can stretch, squash, bend or twist an object. The load is the force stretching a spring, usually the weight of hanging masses. The extension, , is its gain in length:
An elastic object returns to its original shape and size once the load is removed.
The experiment (Core)
- Hang the spring from a clamp stand. Fix a metre rule upright next to it and attach a pointer to the spring's lower end.
- Read the pointer's position with no load.
- Add 100 g slotted masses singly; each adds 0.98 N of load ( = 9.8 N/kg).
- Each time, let the spring settle, then read it with your eye in line with the pointer (no parallax).
- Subtract the first reading from the others to get the extensions, and plot them against the load.
Reading the graph (Core)
For a metal spring, the graph starts off straight and passes through the origin. Equal steps of load give equal steps of extension: the extension is directly proportional to the load. For larger loads the graph curves, as each extra newton stretches the spring further than the last. A rubber band springs back too, yet its graph curves almost from the start.
Books often call this Hooke's law; the syllabus does not, so describe the relationship.
The spring constant (Supplement)
The spring constant is the force per unit extension:
with in N, in m and in N/m (or N/cm, if is in cm). A stiffer spring has a larger . With load on the vertical axis and extension on the horizontal axis, the gradient of the straight part is ; with the axes swapped, it is .
The limit of proportionality (Supplement)
Beyond the limit of proportionality, extension and load stop being directly proportional. On the graph, it is where the straight line ends. Use only for readings up to it.
Worked example: testing a spring (Core, then Supplement)
A student in Nairobi loads a spring, 6.0 cm long with no load, in 1.5 N steps. Each step up to 6.0 N adds 2.0 cm; at 7.5 N the spring is 17.0 cm long.
(Core) Up to 6.0 N (8.0 cm) the extension rises in equal steps, so it is proportional to the load. At 7.5 N it is 11.0 cm, not the predicted 10.0 cm: the graph has begun to curve.
(Supplement) With the extension in metres:
The limit of proportionality lies between 6.0 N and 7.5 N.
Simulation tasks
In the simulation above, the Soft spring hangs empty: the Length card shows its original length, 5.00 cm.
- (Core) Press Record, then Add and Record in turn up to 500 g. Each 100 g adds 0.980 N and 2.45 cm, and the points on the Load–extension graph form a straight line from the origin.
- (Core) Add a sixth mass (600 g) and record. The extension is 15.82 cm, not 14.70 cm: the point leaves the line, and the status reads Past the limit of proportionality.
- (Supplement) The graph now marks the limit of proportionality (5.2 N). Press Remove once. With 500 g on, the working under the cards gives = 4.90 N ÷ 0.1225 m = 40.0 N/m, as does the Gradient (tangent) tool.
- (Supplement) Remove every mass, choose Stiff spring (the table clears) and record up to 700 g. Each 100 g now stretches it half as far, and Spring constant reads 80 N/m.
- (Core) Remove every mass again, choose Rubber band, then record a reading after each mass you add. Its points curve from the start, and Spring constant says not constant.
Skip the Energy stored card, the two-spring set-ups and very heavy loads: they go beyond this topic.