What resistance tells you (Core)
Every component opposes the flow of charge through it to some extent. That opposition is its resistance. For the same p.d., a component with a large resistance lets only a small current through, and one with a small resistance lets a large current through.
Resistance is measured in ohms (Ω). Cambridge expects every candidate to recall the equation that defines it:
where is the resistance in Ω, is the p.d. across the component in V and is the current through it in A. One ohm is one volt per ampere. You will often need the rearranged forms and .
Finding a resistance by experiment (Core)
This is a Cambridge syllabus experiment, and you should be able to describe it and do the calculations.
- Connect a power supply, a switch, an ammeter and the resistor (or a length of wire) in series. Add a variable resistor in the same loop so you can change the current.
- Connect a voltmeter in parallel, directly across the resistor.
- Close the switch, read the ammeter and the voltmeter, then open the switch again.
- Adjust the variable resistor and take several more pairs of readings.
- Work out for each pair and find the mean.
You can also plot a graph of p.d. on the vertical axis against current on the horizontal axis. For a resistor of constant resistance it is a straight line through the origin, and its gradient equals the resistance.
Use small currents and open the switch after each reading. If the wire warms up, its resistance changes and the results are spoiled.
Length and thickness of a wire
A metal wire is a resistor in its own right. Two features of its shape matter.
- Length (Core): a longer wire has a greater resistance.
- Cross-sectional area (Core): a thicker wire, with a bigger cross-sectional area, has a smaller resistance.
A simple picture helps. A longer wire gives the drifting electrons a longer journey through the metal. A thicker wire is like a wider road, with room for more electrons to move side by side.
Sketching current–voltage graphs for a fixed resistor, a filament lamp and a diode is a Supplement skill with its own topic page in this course.
Worked example 1 (Core)
A torch lamp has a p.d. of 3.0 V across it and a current of 0.25 A through it. Calculate its resistance.
Equation and substitution:
Answer: Ω.
Worked example 2 (Supplement)
A 0.50 m length of nichrome wire has a resistance of 4.0 Ω. Find the resistance of (a) 1.5 m of the same wire and (b) a 0.50 m nichrome wire with twice the cross-sectional area.
(a) The length is 3 times larger, so the resistance is 3 times larger:
(b) Twice the area means half the resistance: Ω.
Test it in the simulation
In the simulation above, wire a cell, an ammeter and a resistor into one loop, with a voltmeter connected across the resistor. Tap the resistor and give it a new value. Each time, divide the voltmeter reading by the ammeter reading: the answer matches the value you set. Then swap in a variable resistor and see the current fall as its resistance rises, while the cell's e.m.f. stays the same.