What this topic covers
Taking the readings (Core)
Connect an ammeter in series with the component and a variable d.c. supply, and a voltmeter across the component alone. Each pair of readings gives there. Turning the component round gives negative values.
Sketching the graphs (Supplement)
A sketch is marked on its shape, not on plotted points. Draw current, , on the vertical axis and voltage, , on the horizontal axis, with the origin at the centre.
| Component | What your sketch must show |
|---|---|
| Resistor of constant resistance | A straight line through the origin, with the same slope on both sides |
| Filament lamp | A curve through the origin, steepest there and less steep as the voltage grows either way; the negative half is a half-turn copy of the positive half |
| Diode | Along the voltage axis for every negative voltage and for small positive ones, then a sharp rise from roughly 0.6 V for silicon |
Why each shape (Supplement)
- Resistor: its resistance is the same at every voltage, so current is directly proportional to voltage.
- Filament lamp: a bigger current heats the filament, and hot metal resists more, so every added volt brings a smaller rise in current. The heating ignores direction, so both halves match.
- Diode: reversed, its resistance is enormous, so the current is almost zero. Forwards, the resistance falls sharply near 0.6 V and the current climbs steeply.
For a resistance at any point, divide by there. With on the vertical axis, a resistor's line has gradient ; the Resistance page plots vertically, which makes the gradient . A curve's slope never gives the resistance.
Worked example 1 (Core and Supplement): a torch lamp
A 2.5 V torch lamp gives 0.10 A at 0.50 V, 0.16 A at 1.2 V and 0.25 A at 2.5 V. Find its resistance at each voltage and explain the trend.
Equation:
Working: , ,
Answer: the resistance doubles, from 5.0 Ω to 10 Ω: the biggest current makes the filament hottest, and hot metal resists more. Plotted, the points lie on a curve bending towards the voltage axis.
Worked example 2 (Supplement): a diode both ways
A silicon diode is in series with a protective resistor. Forwards, the voltmeter across the diode reads 0.68 V and the ammeter 17 mA. Reversed, they read −3.0 V and 0.0 mA.
Given: V, mA A
Equation:
Substitution:
Answer: forwards. Reversed, cannot be worked out with zero current: the resistance is too large to measure.
A diode's circuit symbol is a triangle with a bar at its tip; the triangle shows which way conventional current may pass. An LED's symbol adds two arrows pointing away; it is a diode too, so it lights only with forward current.
Explore the graphs yourself
In the simulation above, a 12 V lamp is set to 6.0 V. Press Take a full set of readings: the power pack steps to 12 V, then to −12 V with the leads reversed. Tap the 12 V point (or 12.00 in the table). gives 24.0 Ω, but 1 ÷ gradient of the tangent gives 46.9 Ω, which is not the resistance.
Next, choose Diode, take a full set and press 0 to 0.8 V above the graph. The current is still 0.00 mA at 0.30 V and climbs steeply beyond about 0.6 V. The biggest forward p.d. in the table is only 0.74 V, as the 470 Ω resistor takes the rest; all four reversed readings show 0.00 mA.
Last, choose Resistor and 10 Ω, take a full set, then repeat with 100 Ω. The gradient under the graph falls from 0.100 to 0.0100 A/V, and 1 ÷ gradient returns each resistance.