Skip to content

GCSE Physics — AQA · Forces and motion

Newton's second law

4.5.6.2.2

Acceleration is directly proportional to the resultant force and inversely proportional to mass, so F = ma (recall it). Required practical 7 tests both links with a trolley. Higher tier: inertial mass is force ÷ acceleration, a measure of how hard velocity is to change.

Loading simulation…

Symbols match your course. Open the full force, mass and acceleration (f = ma) simulation for more presets and teacher tools.

What spec point 4.5.6.2.2 covers

On both tiers you need the proportionality statements, the equation, estimates of forces in road transport, and Required practical 7. Inertial mass is Higher tier only.

F=maF = ma is not on the equation sheet, so you must remember it: resultant force FF in N, mass mm in kg, acceleration aa in m/s².

How force, mass and acceleration are linked

  • Keep the mass the same, and the acceleration is directly proportional to the resultant force: a∝Fa \propto F. Twice the force gives twice the acceleration.
  • Keep the resultant force the same, and the acceleration is inversely proportional to the mass: a∝1ma \propto \dfrac{1}{m}. Twice the mass gives half the acceleration.

Together these give F=maF = ma. So 1 N is the resultant force needed to accelerate 1 kg at 1 m/s². Always use the resultant force, never just the biggest force in the question.

Worked example 1: an e-scooter. A rider and scooter have a total mass of 90 kg. The motor gives a forward force of 150 N and resistive forces total 42 N.

Given: F=150−42=108F = 150 - 42 = 108 N forwards, m=90m = 90 kg. Equation: F=maF = ma, so a=Fma = \dfrac{F}{m}. Substitution: a=10890a = \dfrac{108}{90}. Answer: a=1.2a = 1.2 m/s² forwards.

Higher tier: inertial mass

Inertial mass tells you how hard it is to change an object's velocity. It is defined as the ratio of resultant force to acceleration, m=Fam = \dfrac{F}{a}. A full supermarket trolley has more inertial mass than an empty one, so the same push changes its velocity less.

Worked example 2. A resultant force of 36 N gives a loaded sledge an acceleration of 0.45 m/s². Equation: m=Fam = \dfrac{F}{a}. Substitution: m=360.45m = \dfrac{36}{0.45}. Answer: inertial mass =80= 80 kg.

Estimating forces on the road

AQA expects sensible estimates. It uses the symbol ∼\sim to mark an approximate value; ≈ means the same and is used below. A family car has a mass of about 1500 kg. In an emergency stop from 20 m/s it might take about 3 s to stop, so a≈203≈7a \approx \dfrac{20}{3} \approx 7 m/s². The braking force is then F≈1500×7≈1×104F \approx 1500 \times 7 \approx 1 \times 10^4 N. A crash can stop a car in about a tenth of a second, so the forces are far larger and can cause serious injuries.

Required practical 7

Aim: find how a trolley's acceleration depends on the force (with mass fixed) and on the mass (with force fixed).

Typical set-up: a trolley on a level bench, a string tied to it running over a pulley at the bench edge, and a hanger with slotted masses on the other end. The weight of the hanging masses provides the pull. Measure the acceleration using light gates and a card fixed to the trolley, or by timing the trolley over marked distances.

Part 1, changing the force: start with several 100 g masses on the trolley. Move them to the hanger one at a time. The pull rises, but the total mass being accelerated (trolley plus hanging masses) stays the same, so it is a fair test.

Part 2, changing the mass: keep the hanging mass fixed and add masses to the trolley. Here mm is the total mass being accelerated, including the hanger.

Results: a graph of aa against FF is a straight line through the origin, showing a∝Fa \propto F. A graph of aa against 1m\dfrac{1}{m} is also a straight line through the origin, showing a∝1ma \propto \dfrac{1}{m}.

Errors and safety: friction shifts the aa–FF line along the force axis, so it misses the origin; tilting the runway slightly so the trolley rolls at a steady speed cancels it. Repeat each run and take a mean. Put a box of soft material under the hanger, and stop the trolley before it leaves the bench.

Using the simulation

In the simulation above, the starting set-up is 100 g hanging, 0.9 kg trolley. Press Play. The pull is the hanger's weight, 0.98 N, acting on 1.0 kg in total, so the acceleration readout shows 0.980 m/s². The velocity–time graph opens with its Gradient (tangent) tool on: drag along the line and compare its gradient with that value and the light-gate result.

Once the card has passed gate 2, press Record beside Play. Next, use Move 100 g to the hanger, run the trolley once more and record that too. Do this a few times. The results graph is already set to a against F, and the points line up through the origin.

Finally, compare 1.0 N pull, empty 0.5 kg trolley with 1.0 N pull, 1.0 kg trolley. Doubling the mass halves the acceleration, from 2.0 m/s² to 1.0 m/s².

Equations

Common mistakes

  • Putting one force into F = ma instead of the resultant force. Subtract the resistive forces from the driving force first.
  • Rearranging wrongly, for example writing a = m ÷ F. Check that a bigger force gives a bigger acceleration.
  • In Required practical 7, adding extra masses to the hanger to change the force. This changes the total mass too, so the test is not fair; move masses from the trolley instead.
  • Dividing the hanging weight by the trolley's mass alone. The pull accelerates the trolley and the hanging masses together.
  • Giving estimates to too many significant figures. An estimate should be one or two significant figures, shown with ~ or ≈.
  • Higher tier: defining inertial mass as the amount of matter in an object. AQA wants how difficult it is to change the velocity, or force ÷ acceleration.

Exam-style questions

Original questions written in the style of GCSE AQA. Try each one before you reveal the answer.

  1. 1.A delivery van has a mass of 2400 kg. When it pulls away, the resultant force on it is 3000 N.

    1. (a)Write down the equation that links resultant force (F), mass (m) and acceleration (a).

      1 mark
      Show the answer

      Answer: F = m a

      Marking points

      • F = m a (resultant force = mass × acceleration)
    2. (b)Calculate the acceleration of the van.

      2 marks
      Show the answer

      Answer: a = 3000 ÷ 2400 = 1.25 m/s² (1.3 m/s² to 2 s.f.)

      Marking points

      • a = 3000 ÷ 2400
      • a = 1.25 m/s² (accept 1.3 m/s²)
    3. (c)Parcels are loaded into the van, so its mass becomes 3000 kg. The resultant force is still 3000 N. Calculate the new acceleration and explain why it is different.

      2 marks
      Show the answer

      Answer: a = 3000 ÷ 3000 = 1.0 m/s². It is smaller because, for a fixed resultant force, acceleration is inversely proportional to mass.

      Marking points

      • a = 1.0 m/s²
      • A greater mass with the same resultant force gives a smaller acceleration (a is inversely proportional to m).
  2. 2.A student wants to find out whether a trolley's acceleration depends on the size of the force pulling it. The trolley is on a level bench. A string attached to the trolley passes over a pulley and holds a hanger with slotted masses.

    1. (a)Describe a method the student could use. Your answer should explain how the student keeps the investigation fair.

      6 marks
      Show the answer

      Answer: Put several slotted masses on the trolley. Release the trolley so that the weight of the hanging masses pulls it along. Measure the acceleration with light gates and a card on the trolley. Transfer a single mass from trolley to hanger, then repeat. This increases the pulling force but keeps the total mass of the trolley plus hanging masses constant. Work out each force from the hanging weight, W = m g. Repeat each run and find a mean acceleration. Plot acceleration against force. (AQA marks 6-mark questions as a whole, by level of response. The marking points below show what a top-level answer covers.)

      Marking points

      • The weight of the hanging masses provides the force that accelerates the trolley.
      • Acceleration measured using light gates and a card (or by timing the trolley over a measured distance).
      • Masses moved from the trolley to the hanger one at a time to increase the force.
      • This keeps the total mass being accelerated constant, so only the force changes.
      • Force calculated from the weight of the hanging masses (W = m g); each run repeated and a mean acceleration found.
      • Acceleration plotted against force to find the relationship.
    2. (b)Name the independent variable and the dependent variable in this investigation.

      2 marks
      Show the answer

      Answer: Independent: the pulling force (weight of the hanging masses). Dependent: the acceleration of the trolley.

      Marking points

      • Independent variable: force (weight of hanging masses).
      • Dependent variable: acceleration.
    3. (c)The student's graph of acceleration against force is a straight line, but it crosses the force axis at 0.15 N instead of passing through the origin. Suggest a reason for this and one way to improve the experiment.

      2 marks
      Show the answer

      Answer: Friction acts on the trolley, so a small force is needed before it accelerates. Tilt the bench or runway slightly so that the trolley rolls at a steady speed with no hanging mass, which compensates for friction.

      Marking points

      • Friction opposes the motion (some of the pull is used to overcome friction).
      • Tilt the runway slightly to compensate for friction (or use a lower-friction track).
  3. 3.Higher tier. A worker pushes a trolley across a smooth warehouse floor. A resultant force of 18 N gives the trolley an acceleration of 1.2 m/s².

    1. (a)State what is meant by inertial mass.

      1 mark
      Show the answer

      Answer: It measures how hard it is to change an object's velocity. It equals resultant force ÷ acceleration.

      Marking points

      • How difficult it is to change an object's velocity (accept force ÷ acceleration).
    2. (b)Calculate the inertial mass of the trolley.

      2 marks
      Show the answer

      Answer: m = F ÷ a = 18 ÷ 1.2 = 15 kg

      Marking points

      • m = 18 ÷ 1.2
      • m = 15 kg
    3. (c)A box is placed on the trolley. The same resultant force now gives an acceleration of 0.80 m/s². Calculate the mass of the box.

      2 marks
      Show the answer

      Answer: New total mass = 18 ÷ 0.80 = 22.5 kg. Mass of box = 22.5 − 15 = 7.5 kg

      Marking points

      • Total mass = 18 ÷ 0.80 = 22.5 kg
      • Mass of box = 7.5 kg
  4. 4.In a low-speed collision, a car travelling at 13 m/s is brought to rest in about 0.10 s.

    1. (a)Estimate the deceleration of the car.

      2 marks
      Show the answer

      Answer: a ≈ 13 ÷ 0.10 ≈ 130 m/s²

      Marking points

      • a = 13 ÷ 0.10
      • a ≈ 130 m/s² (accept 100 m/s² to 150 m/s²)
    2. (b)The driver has a mass of about 70 kg. Estimate the resultant force on the driver while the car stops.

      2 marks
      Show the answer

      Answer: F ≈ 70 × 130 ≈ 9100 N, about 9000 N (about 1 × 10⁴ N).

      Marking points

      • F = 70 × 130 (allow their deceleration from the part above)
      • F ≈ 9000 N (accept 7000 N to 11 000 N)
    3. (c)Explain why large decelerations like this are dangerous for the people in the car.

      1 mark
      Show the answer

      Answer: A large deceleration means a large resultant force acts on each person, which can cause serious injury.

      Marking points

      • Large deceleration needs a large force on the body, which can cause injury.

Quick check

6 questions

  1. 1.A resultant force of 12 N acts on a box of mass 3.0 kg. What is its acceleration?
  2. 2.The resultant force on a trolley is doubled and its mass stays the same. What happens to its acceleration?
  3. 3.In Required practical 7, why are masses moved from the trolley to the hanger instead of adding new masses to the hanger?
  4. 4.Which graph shows that acceleration is inversely proportional to mass?
  5. 5.Higher tier: a resultant force of 50 N gives an object an acceleration of 2.5 m/s². What is its inertial mass?
  6. 6.A car of mass about 1000 kg decelerates at about 5 m/s² when braking. Which is the best estimate of the braking force?