Stopping distance in the AQA course
This covers spec points 4.5.6.3.1 to 4.5.6.3.4, mostly on both tiers, with two extras:
- GCSE Physics only (not Combined Science): estimate the emergency stopping distance of one particular vehicle across the speeds it normally drives at, and read graphs comparing stopping distance and speed for different vehicles. (Estimating how emergency stopping distances change across typical road speeds in general is on both courses.)
- Higher tier only: estimate the forces that slow road vehicles in everyday driving.
You must remember these three equations; none is on the equation sheet:
- distance travelled = speed × time:
- kinetic energy:
- work done = force × distance:
Thinking distance plus braking distance
A vehicle stops in two stages:
The thinking distance is covered during the reaction time, from seeing the hazard to the brakes starting to act. The braking distance is covered from then until the vehicle is at rest.
Reaction time and thinking distance
Each person is different, but most take 0.2 s to 0.9 s to react. During that time the vehicle keeps its speed, so the thinking distance is speed × reaction time. With the reaction time unchanged, doubling the speed doubles the thinking distance.
Tiredness, alcohol and drugs (including some medicines) all slow a driver's reactions, so they lengthen the thinking distance. Distractions such as a phone call can delay a response too.
To measure reaction times in class, use a ruler drop test. A partner holds a ruler vertically, its zero mark level with your open finger and thumb, and lets go without warning. You catch it as fast as you can; a conversion table turns the distance it fell into a time. Repeat several times and take a mean. Clicking when a computer screen changes colour works too. Results usually sit near the quick end of the range, because you are ready and waiting.
Factors that affect braking distance
Braking distance grows with speed. It is also longer when the road is wet or icy (the tyres grip less), when the brakes are worn, or when the tyres are worn with too little tread. A heavier load makes it longer too, because the same braking force then gives a smaller deceleration (). Road, brakes, tyres and load do not affect the thinking distance.
Where the kinetic energy goes
When the brakes are applied, friction between the brakes and the wheels does work on the vehicle. This reduces its kinetic energy and heats up the brakes. If the brakes alone stop the car, the work they do equals all its kinetic energy:
At the same braking force, doubling the speed gives four times the kinetic energy, so the braking distance quadruples. So stopping a faster car within the same distance takes a bigger braking force. Harder braking means a bigger deceleration, and very large decelerations are dangerous: the brakes may overheat, the tyres may skid so the driver loses control, and the people inside feel large forces.
Worked example: a car on a dual carriageway
A car of mass 1200 kg travels at 20 m/s near Leeds. The driver reacts in 0.70 s, and the braking distance is 40 m.
(a) Thinking distance. Given: m/s, s. Equation: . Substitution: . Answer: m
(b) Stopping distance. m
(c) Higher tier: braking force. Equation: . Substitution: J. The brakes do this much work, so gives . Answer: N
Using the simulation
In the simulation above, choose the scenario Exam-style numbers: 20 m/s, 0.7 s, 5 m/s² and press play. The readouts match the worked example: 14.0 m, 40.0 m and 54.0 m. In the Braking controls, pick Force and mass. Its starting values, 1200 kg and 6 kN, keep the deceleration at 5 m/s², and the Energy check shows 240 kJ for both the brakes' work and the starting kinetic energy. Then return to Road surface, swap between Dry, Wet and Icy, and try each option under How is the driver? Which part of the road changes each time?