Skip to content

GCSE Physics — AQA · Energy

Conservation and dissipation of energy

4.1.2.1

Energy is never made or destroyed, so the total in a closed system stays the same. Every real change dissipates some energy into thermal stores of the surroundings, where it is hard to use. Lubrication and insulation cut unwanted transfers. Both tiers; Required practical 2 is physics only.

Loading simulation…

Symbols match your course. Open the full energy stores and transfers simulation for more presets and teacher tools.

What AQA asks for (spec 4.1.2.1)

Spec point 4.1.2.1 is for both tiers, whether you take GCSE Physics or Combined Science. No equation comes with it. You should be able to:

  • use the rule that energy is never created or destroyed, especially for closed systems
  • give examples showing that every real change dissipates some energy
  • explain how lubrication and thermal insulation reduce unwanted energy transfers
  • describe how wall thickness and thermal conductivity affect how fast a building cools.

Required practical 2, comparing thermal insulators, is for GCSE Physics only. You never need to define thermal conductivity.

Energy is conserved

No process can make energy out of nothing or make it disappear. After any change, every joule is still somewhere: in a useful store, in its old store, or spread into the surroundings. Physicists call this the principle of conservation of energy.

A closed system is one where no energy enters or leaves. Inside it, energy can move between stores in any way, but the total stays exactly the same.

Worked example: a sledge run. A child and sledge, 30 kg in total, start from rest and slide down a slope that drops 8.0 m vertically. At the bottom they are moving at 9.0 m/s. Take g=9.8g = 9.8 N/kg. How much energy is dissipated on the way down?

Given: m=30m = 30 kg, h=8.0h = 8.0 m, v=9.0v = 9.0 m/s. Equations: Ep=mghE_p = mgh and Ek=12mv2E_k = \frac{1}{2}mv^2. Substitution: gravitational potential energy lost =30×9.8×8.0=2352= 30 \times 9.8 \times 8.0 = 2352 J; kinetic energy gained =12×30×9.02=1215= \frac{1}{2} \times 30 \times 9.0^2 = 1215 J. Answer: dissipated energy =2352−1215=1137= 2352 - 1215 = 1137 J, about 1100 J (2 s.f.). Friction and air resistance warmed the runners, snow and air. Check: 1215 J + 1137 J = 2352 J.

Dissipation: still there, but less useful

In every real change, some energy ends up where nobody wanted it, usually in thermal stores of the surroundings: friction warms moving parts, a current warms wires, and even sound fades into slightly warmer air. This energy is dissipated. It is now so spread out that putting it back to work is almost impossible. People often call it wasted, but it has not vanished.

Cutting unwanted energy transfers

  • Lubrication. Oil or grease between rubbing surfaces reduces friction, so less energy is transferred by heating. That is why bicycle chains and engine parts are oiled.
  • Thermal insulation. Materials that let energy pass through only slowly reduce heating of the surroundings: foam lagging on a hot-water tank, wool in a loft, a padded winter coat.

Walls, thickness and thermal conductivity

Copper has a high thermal conductivity, so energy is conducted through it quickly. Foam has a low thermal conductivity, so energy creeps through it slowly. A house loses energy through its walls more slowly, and so cools more slowly, when the walls:

  • are made from materials with a lower thermal conductivity, such as foam in the cavity between brick layers
  • are thicker, so the energy has further to travel.

In double glazing, the gas between the panes has a low thermal conductivity.

Required practical 2 (GCSE Physics only)

Pour equal volumes of hot water, all at the same starting temperature, into identical beakers. Wrap each in a different material of the same thickness, then record the temperature regularly for a fixed time, such as 10 minutes. The material with the smallest temperature drop is the best insulator. Another version changes the number of layers of one material. Take care with hot water to avoid scalds.

Using the simulation

In the simulation above, set the Scenario to Car braking to a stop. Under the cards it reads "Total right now: 135 kJ. At the start: 135 kJ." Press Play: the total holds steady, since car, brakes, road and air form a closed system. In Energy at key moments, press Show under Half the starting speed. The Kinetic store of the car holds 33.8 kJ, a quarter of its starting value; the Thermal store of the brakes has 98.9 kJ. By the end all 135 kJ is dissipated, so Useful shows 0 kJ. Switch on Regenerative braking, and 79.3 kJ ends up in the Chemical store of the battery instead.

Next choose Ball thrown straight up. Air resistance is already on: 1.16 J of the ball's 6.53 J is dissipated before it reaches the top. Switch it off and nothing is dissipated, which no real ball manages.

Common mistakes

  • Writing that energy is lost or used up. It is transferred to another store, usually the thermal store of the surroundings, so the total is unchanged.
  • Saying that dissipated energy has been destroyed. It still exists, but it is spread out so thinly that it is hard to use.
  • Thinking lubrication removes friction completely. It reduces friction between moving parts, so less energy is transferred by heating.
  • Mixing up the meaning of thermal conductivity. A material with a high thermal conductivity conducts energy quickly, so it makes a poor insulator.
  • Stating that thick walls stop a house cooling. They lower the rate of energy transfer, so the house still cools, but more slowly.
  • In Required practical 2, letting more than one thing change, such as the volume or starting temperature of the water. Keep these the same and change only the insulating material.

Exam-style questions

Original questions written in the style of GCSE AQA. Try each one before you reveal the answer.

  1. 1.A roller-coaster car and its riders have a total mass of 400 kg. The car begins at rest on top of a slope and drops 25 m vertically. At the bottom it is moving at 20 m/s. Gravitational field strength = 9.8 N/kg.

    1. (a)Calculate how much energy is transferred from the gravitational potential store as the car goes down the slope.

      2 marks
      Show the answer

      Answer: E_p = m g h = 400 × 9.8 × 25 = 98 000 J

      Marking points

      • E_p = 400 × 9.8 × 25
      • E_p = 98 000 J
    2. (b)Calculate the kinetic energy of the car at the bottom of the slope.

      2 marks
      Show the answer

      Answer: E_k = 0.5 × 400 × 20² = 80 000 J

      Marking points

      • E_k = 0.5 × 400 × 20²
      • E_k = 80 000 J
    3. (c)Calculate the energy dissipated on the way down, and state where this energy goes.

      3 marks
      Show the answer

      Answer: 98 000 − 80 000 = 18 000 J. It is transferred to the thermal stores of the wheels, track and air.

      Marking points

      • 98 000 − 80 000 (allow their values from the parts above)
      • = 18 000 J
      • To thermal stores of the surroundings (wheels, track and air).
    4. (d)Suggest one way the designers could reduce the energy dissipated.

      1 mark
      Show the answer

      Answer: Lubricate the wheel bearings to reduce friction (or streamline the car to reduce air resistance).

      Marking points

      • Lubricate the wheels or bearings (accept streamline the car).
  2. 2.A builder can make the outer walls of a house from one of three materials, P, Q and R. Their thermal conductivities are: P 0.80 W/m °C, Q 0.15 W/m °C, R 0.035 W/m °C. Whichever material is chosen, the walls will be the same thickness.

    1. (a)Which material would make the house cool most slowly? Give a reason for your answer.

      2 marks
      Show the answer

      Answer: R, because it has the lowest thermal conductivity, so the rate of energy transfer by conduction through it is lowest.

      Marking points

      • R
      • Lowest thermal conductivity, so the lowest rate of energy transfer (by conduction) through the wall.
    2. (b)Apart from the material, state one other property of the walls that affects how quickly the house cools, and describe its effect.

      2 marks
      Show the answer

      Answer: The thickness of the walls. Thicker walls make the house cool more slowly.

      Marking points

      • Thickness of the walls
      • Thicker walls give a lower rate of cooling.
    3. (c)Explain, in terms of energy, why the house cools down when the heating is switched off on a cold day.

      2 marks
      Show the answer

      Answer: The inside of the house is warmer than the outside, so energy is transferred by heating from the thermal store of the house, through the walls, to the thermal store of the surroundings outside.

      Marking points

      • Energy is transferred from the thermal store of the house (by heating, through the walls) …
      • … to the thermal store of the colder surroundings outside.
  3. 3.GCSE Physics only (Required practical 2). A student investigates how well two materials, A and B, work as thermal insulators, using beakers of hot water.

    1. (a)Describe a method the student could use.

      4 marks
      Show the answer

      Answer: Wrap one beaker in material A and an identical beaker in the same thickness of material B. Pour the same volume of hot water at the same starting temperature into each. Measure the temperature with a thermometer at the start and after a fixed time, such as 10 minutes. Work out each temperature drop: the smaller drop shows the better insulator.

      Marking points

      • Identical beakers wrapped in equal thicknesses of each material.
      • The same volume of water at the same starting temperature in each.
      • Temperature measured at the start and after a fixed time (or at regular intervals) with a thermometer.
      • The temperature drops compared: the smallest drop shows the best insulator.
    2. (b)Give one control variable in this investigation.

      1 mark
      Show the answer

      Answer: For example: the volume of water, the starting temperature, the thickness of material or the time between readings.

      Marking points

      • Any one of: volume of water; starting temperature; thickness of the material; time interval; size of beaker.
    3. (c)After 10 minutes, the water wrapped in material A had cooled by 18 °C and the water wrapped in material B by 11 °C. An unwrapped beaker cooled by 25 °C. Which material is the better insulator? Explain your answer.

      2 marks
      Show the answer

      Answer: Material B. Its water had the smallest temperature drop, so energy was transferred to the surroundings at the lowest rate.

      Marking points

      • Material B
      • Smallest temperature drop, so the lowest rate of energy transfer to the surroundings.
  4. 4.An electric drill becomes warm and noisy when it is used for a long time.

    1. (a)State the principle of conservation of energy.

      1 mark
      Show the answer

      Answer: Energy can never be created or destroyed, so the total stays the same; it can only move between stores or spread out.

      Marking points

      • Energy cannot be created or destroyed.
    2. (b)Explain why the energy that warms the drill is described as wasted.

      2 marks
      Show the answer

      Answer: It goes into the thermal stores of the drill and the surrounding air, which is not the job the drill is for. It spreads out, so it cannot easily be used again.

      Marking points

      • It is transferred to thermal stores of the drill and the surroundings, not to the intended (useful) store.
      • It is spread out (dissipated), so it cannot easily be used.
    3. (c)Explain how oiling the gears inside the drill reduces the wasted energy.

      2 marks
      Show the answer

      Answer: Oil lubricates the gears, which reduces the friction between them. Less work is done against friction, so less energy is dissipated by heating.

      Marking points

      • Lubrication reduces friction between the moving gears.
      • So less energy is transferred by heating (dissipated) to thermal stores.

Quick check

6 questions

  1. 1.Energy is transferred between stores inside a closed system. What happens to the total energy of the system?
  2. 2.Where does most dissipated energy end up?
  3. 3.Which walls would make a house cool most slowly?
  4. 4.Why is a bicycle chain oiled?
  5. 5.As a ball rises, its kinetic store decreases by 50 J and its gravitational potential store increases by 42 J. How much energy has been dissipated?
  6. 6.A playground swing is pushed once and left. It gradually stops swinging. Which statement is correct?