Skip to content

Turning effects simulation

Centre of Mass and Stability Simulation

Raise a tilting platform under a bookcase, a double-decker bus or a racing car and watch the line of action of the weight cross the pivot edge. Compare stable, unstable and neutral equilibrium, and find a card's centre of mass with a plumb line.

Loading simulation…
Show symbols for

Predict first

Question 1 of 4

A bookcase on the tilting platform usually keeps its 40 kg of books on the bottom shelf. This time the books are all on the top shelf. As the platform is raised slowly, how does the angle at which it starts to tip compare?

Try this

  1. 1With the bookcase's books on the Bottom shelf, press Tilt. When it starts to go over, compare the angle it began to tip at with the critical angle in the readout.
  2. 2Press Reset to level the platform, then move the books to the Top shelf. Predict whether it will now tip at a bigger or a smaller angle, then press Tilt to check.
  3. 3Choose the Double-decker bus and compare the critical angle with the passengers Downstairs and Upstairs. Then drag the Base width slider and watch the critical angle change.
  4. 4Press Tip a few times to lean the object over by hand, then press Let go. Find the biggest lean it still recovers from (press Reset if it topples).
  5. 5Open Plumb line, choose the Boomerang card, and mark lines from holes A and B. Where do they cross?

What this simulation shows

A steel platform in a test bay is hinged along one edge. Stand a bookcase, a double-decker bus, a racing car, a floor lamp or a plain block on it, then raise the platform slowly with the Tilt button. At some angle the object lifts off its uphill edge and crashes onto the padded mat. The simulation records that angle on the scale and in the readouts.

Everything that decides the result is drawn on the stage. The chequered disc is the centre of mass, G. (Some courses, including Cambridge IGCSE and the Punjab textbook, call it the centre of gravity. Near the Earth, where gravity is the same throughout an object, the two are at the same point.) The dashed line hanging straight down from it shows where the weight acts. The glowing strip is the base, and the orange dot at the hinge is the pivot edge the object turns about.

The tipping condition

While the dashed line from G still meets the base, the weight has a moment about the pivot edge that presses the object back onto its base, and the line glows green. Tilt further and G drifts sideways until it is directly over the pivot edge. One step beyond that, the line misses the base, turns red, and the same moment now rolls the object over.

That balance point is the critical angle. With G a height hh above the middle of a base of width bb, a little trigonometry gives

tan⁡θc=b/2h\tan\theta_c = \frac{b/2}{h}

For a base 2 m wide with G 2 m up, tan⁡θc=0.5\tan\theta_c = 0.5 and θc=26.57°\theta_c = 26.57°. The dashed outline on the stage shows the object turned to exactly this angle, with G straight above the edge.

Lower and wider means steadier

Two changes raise the critical angle: widening the base, and bringing G down. With the books on the bottom shelf, the bookcase's centre of mass sits 0.5 m up. Move the same books to the top shelf and it rises to 1.3 m, so the bookcase goes over at about 11° instead of 27°. Passengers upstairs do the same to the bus. The racing car, low and wide, hangs on until about 72°.

The panel shows how h comes from the parts: multiply each mass by the height of its own centre of mass, add these up, then divide by the total mass.

Tipping by hand

Press Tip, or drag the object, to lean it over its edge while the platform stays put. Let go below the critical angle and it drops back onto its base with a thud. Let go beyond it and it topples. Leaning is not the same as falling: what matters is which side of the pivot edge G is on.

States of equilibrium

The Equilibrium experiment has three set-ups on a level table. A cone on its base lifts its centre of mass when tipped slightly, then settles back: stable equilibrium. Balanced on its point, the same cone lowers G as soon as it leans, and keeps going: unstable equilibrium. A cylinder on its side can be rolled anywhere without its centre of mass changing height, so it stays wherever it is left: neutral equilibrium.

Finding a centre of mass with a plumb line

In the Plumb line experiment a flat card hangs from a pin. It swings, then stops with G straight below the pin, on the plumb line. Mark that line, hang the card from a different hole and mark again. The two lines cross at the centre of mass. On the boomerang they meet in the empty gap between its arms, because a centre of mass does not have to lie on the object itself.

For more on turning effects, try the principle of moments simulation.

What the model assumes

The platform grips well enough that nothing ever slides, so objects can only tip. Each object is symmetrical, so G sits above the middle of its base. The masses and sizes are realistic examples, not measurements of any real vehicle or product.

Check your understanding

8 questions

  1. 1.The base of a crate measures 0.6 m across, and G is 0.4 m above the middle of the base. What is tan θc for tipping over one edge?
  2. 2.Which change makes an object harder to topple?
  3. 3.An object stands on a slope that is slowly getting steeper. Assuming it cannot slide, when does it start to topple?
  4. 4.A uniform block has a base 1.2 m wide and its centre of mass 0.6 m above the base. What is its critical angle?
  5. 5.A flat card hangs freely from a pin and stops swinging. Where is its centre of mass?
  6. 6.A cone balanced on its point is in which kind of equilibrium?
  7. 7.Why are racing cars built low with their wheels far apart?
  8. 8.The books in a bookcase are moved from the bottom shelf to the top shelf. What happens to its stability?

For teachers

Embed it in your site or open it full-screen for the projector.

Read more