When is a body in equilibrium?
A body is in equilibrium when it has no acceleration. Its velocity does not change at all: not in size and not in direction. By Newton's second law, zero acceleration means the resultant of all the forces on the body is zero. By the first law, such a body is either at rest or moving with uniform velocity.
Your textbook names the two possibilities:
- Static equilibrium: the body is at rest. A water tank standing on a rooftop, a framed photograph hanging on a nail and a lantern hanging from a hook are all in static equilibrium.
- Dynamic equilibrium: the body moves with uniform velocity. A car cruising at a steady speed on a straight stretch of the motorway, a lift rising at a constant speed and a raindrop falling at terminal velocity are all in dynamic equilibrium.
Both kinds have forces acting on them. The forces simply cancel.
First condition of equilibrium
Put into and the net force must be zero:
First condition of equilibrium: the external forces acting on a body must have a vector sum of zero. A body that meets it is in translational equilibrium: it does not speed up, slow down or change direction.
When the forces lie at angles, resolve each one into rectangular components and add the components separately. The first condition then becomes two equations:
Second condition of equilibrium
A zero resultant force does not stop a body from turning. Lay a metre rule flat on a table. Push one end away from you and pull the other end towards you, with equal forces at right angles to the rule. The forces cancel, so the first condition holds, yet the rule spins. The two forces act along different lines, and together they form a couple.
So a second condition is needed for rotational equilibrium: the torques on the body must cancel, so that their sum about any point is zero, . A body is in complete equilibrium only when both conditions hold. Torque is covered in section 4.3 and the principle of moments in section 4.6.
Worked numerical 1: dynamic equilibrium
A box of mass 30 kg is pulled across a level floor at a constant velocity by a horizontal rope. The friction on it is 90 N. Find the tension in the rope and the normal force. Take .
The velocity is constant, so the box is in dynamic equilibrium and , .
Horizontal: , so .
Vertical: the weight is . The normal force must cancel it, so the normal force is 300 N upwards.
Worked numerical 2: forces at angles
Three ropes pull on a ring, each with a force of 6 N. One pulls straight up (90°). The others pull at 210° and 330°, measured anticlockwise from the right. Show that the ring is in equilibrium. Use and .
| Force | x-component (N) | y-component (N) |
|---|---|---|
| 6 N at 90° | 0 | +6 |
| 6 N at 210° | −6 cos 30° = −5.20 | −6 sin 30° = −3 |
| 6 N at 330° | +6 cos 30° = +5.20 | −6 sin 30° = −3 |
Both sums are zero, so the first condition is met.
Exploring equilibrium in the simulation
In the simulation above, every arrow starts at the centre of the object, so all the forces act through one point. Forces like these cannot turn the object, which means the simulation tests the first condition only.
Choose Three ropes in balance to see worked numerical 2. Tap each Tension chip under Forces in turn. The line Components of this force gives that rope's x- and y-components, while the Horizontal total and Vertical total readouts both stay at 0.
Box on a table shows static equilibrium. Skydiver at terminal velocity shows dynamic equilibrium: the panel still reads Balanced forces, and What next? gives Constant velocity.
Finally, choose Tug of war: unbalanced and press Balance. The simulation adds the one force that restores equilibrium: 30.0 N, pointing opposite to the resultant.