Centre of gravity
Any body is built from a huge number of tiny particles, and the Earth pulls every one of them downwards. For an object of everyday size, is practically the same for all the particles, so these pulls are like parallel forces. Their resultant is the weight of the whole body:
Centre of gravity (G): the point at which the whole weight of a body appears to act.
Support a body exactly at G, or directly below it, and it stays balanced without turning. Its weight then passes through the support, so the weight has no moment about it. That is why a ruler balances on one fingertip only at its middle.
G of regular shapes
For a uniform body with a regular shape, G lies at its geometric centre.
| Uniform body | Position of G |
|---|---|
| Metre rule | Its midpoint, the 50 cm mark |
| Round plate or disc | Its centre |
| Cylinder | The middle of its axis |
| Sphere | Its centre |
| Triangular sheet | Where the three medians meet (a median runs from a vertex to the midpoint of the side facing it) |
| Square or rectangular sheet | Where the two diagonals cross |
G does not have to lie in the material itself. A steel bangle has its G at its centre, in empty space, and so does a ring.
Plumb line method for an irregular lamina
A lamina is a thin flat sheet, such as a piece of cardboard cut to an odd shape.
- Punch three small holes close to the rim of the card, far from one another.
- Hang the card from a pin through one hole so that it can swing freely. Let a plumb line, which is a fine thread carrying a small bob, hang from that same pin.
- When both are still, mark two points under the thread and join them with a straight line.
- Hang the card from a second hole and repeat. G is where the two lines cross.
- To check, hang the card from the remaining hole. That third line should pass through the same point.
A freely hanging body comes to rest with G directly below the point of suspension. If G were to one side, the weight would have a moment about the pin and the card would keep turning.
Centre of mass
A body that spins or wobbles while it moves has parts going in many directions at once. Yet one special point in it moves in a simple way: put the resultant force and the total mass into , and you get the acceleration of that point.
Centre of mass: the point at which the whole mass of a body can be taken to be concentrated.
Picture a hockey stick sliding and spinning across smooth ice. Its ends trace loops, but its centre of mass moves in a straight line at a steady speed, because no resultant force acts on the stick.
Near the Earth's surface, is almost uniform over any ordinary object. There the centre of mass and the centre of gravity are at the same point, so the two names can be used for one point G.
Worked numerical: where does a loaded pole balance?
A uniform wooden pole 2.0 m long has a mass of 3 kg. A 2 kg lantern hangs from end A. Where must the pole be supported so that it stays level? Take .
Data: at the middle of the pole, 1.0 m from A; at A; support at distance from A.
The support must push up with the total weight, . Take moments about A (the lantern's weight has no moment there):
This point is the centre of gravity of the pole and lantern together. Check: about the support, and .
Using the simulation
In the simulation above, choose Plumb line under Experiment. An Irregular card hangs from hole A, and the readout says Hanging at rest. G is not marked yet; you will find it. The sim calls the point where your lines cross the centre of mass, and for this card it is also the centre of gravity.
- In the bar under the stage, press Mark line.
- Press B. The card swings, then settles. Once it shows Hanging at rest again, press Mark line. The readout reports that the lines cross on the card, 0 mm from the centre of mass worked out from its shape.
- Press C and mark a third line. It passes through the same point.
- Under Card shape, choose Triangle. A new card starts with no lines, so mark lines from two holes again: they follow the medians. Then do the same with Boomerang: the lines cross in the gap between its arms, off the card.
Press Clear to rub the lines out and start again.