What this topic covers
An object behaves as if all of its weight acts at one point. Where that point sits decides how easily the object topples.
What the centre of gravity is (Core)
The centre of gravity is the single point through which an object's whole weight can be taken to act. On a force diagram, draw the weight as one arrow from there.
For a uniform, symmetrical object it is at the geometric centre: the middle of a metre rule, or the crossing point of a rectangle's diagonals. It need not be in the material. For a ring, or a card bent into a V, it is in the gap.
The simulation labels this point G, the centre of mass. Near the Earth the two coincide, but Cambridge answers should say centre of gravity.
Worked example: balancing a pole (Core)
A painter in Lisbon carries a 2.0 m pole, thicker at end A, on the left. Its 60 N weight acts at its centre of gravity, 0.80 m from A, where it balances on a support. A 15 N paint tin is then hung from end B. How far from A must the support now be?
Method: let the support be from A. The pole's weight now gives an anticlockwise moment, and the tin a clockwise one.
Answer: 1.04 m from A, 0.24 m nearer the tin.
Finding the centre of gravity of a lamina (Core)
A plane lamina is a thin, flat object, here an irregular piece of card.
- Pierce three small holes close to the rim, spaced widely around it.
- Hang the card on a pin held in a clamp and stand, so it can swing freely. Hang a plumb line (thread and small weight) from that pin as well.
- Once everything has stopped moving, mark the thread's position with two well-separated crosses, then rule a line through them.
- Rehang the card from another hole and draw a second line. They intersect at the centre of gravity. A check line from the remaining hole should cross there too.
Why it works: when the card hangs still there is no resultant moment about the pin, so the weight's line of action runs vertically through the pin. Every line drawn this way passes through the centre of gravity.
Stability (Core)
An object is stable if it settles back after a small tilt. Picture a vertical line drawn down from its centre of gravity (the weight's line of action):
- If this line still meets the base, the weight's moment about the tipping edge pulls the object back down.
- If the tilt carries the line beyond the edge of the base, that moment acts the other way and the object topples.
A low centre of gravity and a wide base both increase how far an object can tilt before this happens, so both make it more stable. Racing cars are low with their wheels far apart, Bunsen burners have heavy bases, and a double-decker bus is easier to tip with its passengers upstairs.
Simulation tasks
In the simulation above, the Tilt test opens with a Bookcase on a level platform, its Books (40 kg) on the Bottom shelf. The working line under the object's controls puts G 0.5 m above the base, and Base width is 0.5 m.
- Press Tilt in the bar under the stage. The platform rises until the bookcase goes over, and Began to tip at 26.57° matches the Critical angle card.
- Choose Top shelf (changing the set-up levels the platform). G rises to 1.3 m and the critical angle falls to 10.89°. Press Tilt: it topples far sooner.
- Drag Base width to 1 m. The critical angle grows to 21.04°.
- Press Tip four times (20°), then Let go: the bookcase falls back. Five presses (25°) and Let go topple it.
- Choose Plumb line. The Irregular card hangs still from hole A. Press Mark line, then B, wait for Hanging at rest and mark again. On the Boomerang, the lines meet in the gap.