Skip to content

Cambridge IGCSE Physics (0625) · Transfer of thermal energy

Convection

2.3.2

Core (the whole of 2.3.2): moving fluid often carries most of the energy through a liquid or gas; a warmed fluid expands, its density falls and it rises while cooler, denser fluid sinks, forming a convection current; potassium permanganate and smoke-box experiments.

Loading simulation…

Symbols match your course. Open the full conduction, convection and radiation simulation for more presets and teacher tools.

What this topic covers

Watch a glass kettle warming on a stove in Istanbul and you can see wavy streaks climbing from the base. Warm water is moving upwards and taking its energy with it. Transfer of thermal energy by a moving fluid is convection (syllabus 2.3.2).

Why warm fluid rises (Core)

  1. Part of a liquid or gas is warmed. Its particles move faster and, on average, spread a little further apart, so that part expands.
  2. Its mass is unchanged but its volume is larger. Since density = mass ÷ volume, its density falls.
  3. The cooler fluid around it is denser. It sinks and flows in underneath, pushing the warmer fluid up.
  4. Away from the heater, the warm fluid cools, becomes denser again and sinks. The circulating loop is a convection current.

Cooling works the other way round. Air beside a cold window loses energy, contracts and sinks towards the floor.

Convection cannot happen in a solid: its particles are held in fixed positions, so the material cannot flow. Conduction is the main route through solids.

Experiments that show convection (Core)

In water. Lower one potassium permanganate crystal through a wide straw so that it sits on the floor of a beaker of cold water, close to one side. Heat gently under that side only. A purple stream rises above the flame, spreads across the surface, sinks down the far side and drifts back along the bottom.

In air. A convection box has a glass front and two chimneys, with a lit candle under one of them. Hold smoking paper above the other chimney. The smoke is pulled down that chimney, crosses the box and leaves through the chimney over the candle, where hot, less dense air is streaming out.

Worked example: using density data (Core)

Water at 20 °C has a density of about 998 kg/m³; at 40 °C it is about 992 kg/m³.

(a) A beaker contains water at both temperatures. Which water rises? The 40 °C water, because it is less dense than the 20 °C water.

(b) Find the volume of 1.000 kg of water at each temperature. Using V=m÷ρV = m \div \rho:

V20=1.000998=1.002×10−3 m3V40=1.000992=1.008×10−3 m3V_{20} = \frac{1.000}{998} = 1.002 \times 10^{-3}\ \text{m}^3 \qquad V_{40} = \frac{1.000}{992} = 1.008 \times 10^{-3}\ \text{m}^3

(c) Explain the change using particles. The mass is the same, but the faster-moving particles are slightly further apart on average, so the water takes up about 0.6% more space. A larger volume for the same mass means a lower density.

Watching the dye

In the simulation above, press Convection in the row of experiment buttons. A burner sits under the left side of the beaker on Medium, and the flame button already reads Flame on. Stage time runs 6 times faster than real time.

  1. (Core) Press Play and follow the purple dye: up above the burner, across the surface, down the right-hand side and back along the bottom.
  2. (Core) Compare the Rising water and Sinking water cards. Once the water is moving, the rising water has the lower density, yet the difference is less than 1 kg/m³.
  3. (Core) The Current card soon reads about 5 mm/s. Choose High under Burner flame and the current speeds up; Low slows it down.
  4. (Core) Press Flame on to take the burner away; the button changes to No flame. On the Speed of the current graph the line falls towards zero, because nothing now keeps the loop turning. Press No flame to put the burner back.
  5. (Core) Switch on Show the flow with arrows to see the whole loop at once.

Common mistakes

  • Writing "heat rises". Energy can travel in any direction. What rises is the warm fluid, because it is less dense than the cooler fluid around it.
  • Saying that the particles grow bigger or lighter when a fluid is warmed. Each particle keeps its size and mass; the particles move further apart, so the same mass takes up a bigger volume.
  • Claiming that convection can happen in a solid. The particles of a solid stay in fixed positions, so the material cannot flow, and energy passes through it by conduction instead.
  • Describing only the warm fluid going up. A full answer also says that cooler, denser fluid sinks to take its place, so the fluid circulates in a loop: a convection current.
  • Thinking that convection needs a heater underneath. Cooling from above works too: fluid cooled at the top becomes denser and sinks, as the air beside a cold window does.
  • Explaining a change in density with mass alone. Density is mass ÷ volume; when a fluid warms, its mass stays the same and its volume increases, so its density decreases.

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A student in Kuala Lumpur places a crystal of potassium permanganate on the bottom of a beaker of cold water, close to one side. The student then heats the beaker gently, directly below the crystal.

    1. (a)Describe the path followed by the purple colour.

      2 marks
      Show the answer

      Answer: It rises above the crystal on the heated side, then moves across the top of the water and sinks on the far side before returning along the bottom.

      Marking points

      • rises above the heated side
      • moves across the top and sinks on the opposite side (returns along the bottom)
    2. (b)Explain why the water above the flame rises.

      3 marks
      Show the answer

      Answer: The water is warmed, so its particles move faster and further apart and the water expands. Its density decreases. It is now less dense than the cooler water around it, so it rises while the cooler, denser water sinks.

      Marking points

      • water is warmed and expands (particles move further apart)
      • its density decreases
      • it is less dense than the surrounding cooler water, so it rises (cooler, denser water sinks)
    3. (c)Name the circulating movement of water shown by the purple colour.

      1 mark
      Show the answer

      Answer: A convection current

      Marking points

      • convection current
    4. (d)State one safety precaution for this experiment.

      1 mark
      Show the answer

      Answer: Handle the crystal with tweezers (or wear eye protection).

      Marking points

      • one from: use tweezers for the crystal; wear eye protection; use a small flame; let the apparatus cool before moving it
  2. 2.A convection box has a glass front and two chimneys, A and B. A lit candle stands under chimney A. A piece of smoking paper is held just above chimney B.

    1. (a)State the direction in which the smoke moves in chimney B.

      1 mark
      Show the answer

      Answer: Downwards, into the box.

      Marking points

      • downwards (into the box)
    2. (b)Explain why the smoke moves in this way.

      3 marks
      Show the answer

      Answer: The candle heats the air above it, which expands and becomes less dense. This warm air rises out through chimney A. Cooler, denser air, carrying the smoke, is drawn in through chimney B to replace it.

      Marking points

      • air above the candle is heated and becomes less dense
      • the warm air rises out through chimney A
      • cooler, denser air (with the smoke) enters through chimney B to replace it
    3. (c)The candle is blown out. Suggest what happens to the flow of smoke after a short time.

      1 mark
      Show the answer

      Answer: The flow slows down and stops, because nothing is heating the air any more.

      Marking points

      • the flow slows and stops (no heating to drive the current)
  3. 3.Water has a density of 998 kg/m³ at 20 °C and 983 kg/m³ at 60 °C.

    1. (a)Some water at 20 °C and some at 60 °C are in the same tank. State which water rises.

      1 mark
      Show the answer

      Answer: The water at 60 °C

      Marking points

      • the 60 °C water
    2. (b)Calculate the volume of 2.0 kg of water at 60 °C.

      2 marks
      Show the answer

      Answer: V = m ÷ ρ = 2.0 ÷ 983 = 2.03 × 10⁻³ m³ (0.00203 m³, or 2.0 × 10⁻³ m³ to two significant figures)

      Marking points

      • V = m ÷ ρ or 2.0 ÷ 983
      • 2.03 × 10⁻³ m³ (0.00203 m³; 2.0 × 10⁻³ m³ accepted)
    3. (c)Use ideas about particles to explain why water at 60 °C is less dense than water at 20 °C.

      2 marks
      Show the answer

      Answer: At 60 °C the particles move faster and are further apart on average. The same mass therefore takes up a larger volume, so the density is lower.

      Marking points

      • particles move faster and are further apart (on average)
      • the same mass occupies a larger volume, so the density is lower
    4. (d)State why convection cannot take place inside a block of ice.

      1 mark
      Show the answer

      Answer: Ice is a solid: its particles are held in fixed positions, so it cannot flow.

      Marking points

      • solid / particles in fixed positions, so it cannot flow
  4. 4.In a hot-water storage tank in a flat in Seoul, the electric heater is near the bottom of the tank, and hot water is piped out from the top.

    1. (a)Explain why the heater is placed near the bottom of the tank.

      2 marks
      Show the answer

      Answer: Water warmed at the bottom becomes less dense and rises, while cooler water sinks down to the heater. This sets up convection currents, so all of the water in the tank is heated.

      Marking points

      • warmed water becomes less dense and rises (cooler water sinks to the heater)
      • convection currents carry energy through all the water
    2. (b)Suggest why the hot water is piped out from the top of the tank.

      1 mark
      Show the answer

      Answer: The hottest water is the least dense, so it collects at the top.

      Marking points

      • the hottest (least dense) water collects at the top

Quick check

6 questions

  1. 1.In which pair of materials can convection currents form?
  2. 2.Why does warm water rise through cooler water?
  3. 3.What happens to the density of a sample of air when it is heated and allowed to expand?
  4. 4.Why can convection not happen in a solid?
  5. 5.A crystal of potassium permanganate is heated on one side of a beaker of water. Where does the purple colour move first?
  6. 6.Which statement describes a convection current?