What this topic covers
Stand a steel spoon and a wooden spoon in hot groundnut soup in Accra: only the steel handle soon gets too hot to touch. Energy travelled along the steel; the spoon itself never moved. This is conduction (syllabus 2.3.1).
Good and bad conductors (Core)
Good thermal conductors, such as copper, aluminium and steel, let energy flow through quickly. Bad thermal conductors, or thermal insulators, such as wood, plastic, wool and still air, let it through only slowly. No insulator stops the flow completely.
Three experiments (Core)
1. Rods, wax and pins. Take rods of different materials that share one length and thickness. Wax a drawing pin to each, the same distance from one end. Heat those ends equally, say in one hot metal block, and time each pin. The first to fall marks the best conductor.
2. Paper on a wood-and-brass rod. Wrap paper tightly over the joint and hold it briefly in a Bunsen flame. The paper chars over the wood but not over the brass, which carries energy away before the paper can burn.
3. Water conducts badly. Trap ice under wire gauze at the bottom of a boiling tube of water, then heat near the top. The top boils while the ice barely melts. Warm water stays at the top, so no convection current carries energy down.
Explaining conduction (Supplement)
Every solid holds its particles in a lattice. Particles at the hot end gain energy and vibrate with a larger amplitude, jostling their neighbours into stronger vibration. Energy passes along the lattice, slowly.
Metals also have free (delocalised) electrons, which belong to no single atom. They gain kinetic energy where the metal is hot, race through the lattice and hand it to particles in cooler parts by colliding with them. This route is far quicker.
Gases and most liquids. Gas particles are far apart, so energy passes on only in occasional collisions. Liquid particles are close but not locked into a lattice, so they pass vibrations on poorly, and they have no free electrons. Mercury, a liquid metal, is an exception.
The middle group. Glass, brick, concrete and stone lack free electrons, so they conduct far less well than metals, yet much better than foam or wool. The simulation's glass rod belongs here.
Worked example: reading pin times (Core)
A class heats the rods in a block set to 250 °C, timing from when the burner is lit.
| Rod | Time for 2 cm pin / s | Time for 14 cm pin / s |
|---|---|---|
| Copper | 18 | 84 |
| Aluminium | 19 | 107 |
| Steel | 36 | 563 |
| Glass | 380 | never fell |
(a) Rank the rods, best conductor first. Copper, aluminium, steel, glass: the earlier a pin falls, the sooner energy reached it.
(b) The nearest copper and aluminium pins fall only 1 s apart. What separates them? The 14 cm pins: 84 s against 107 s. The gap widens with distance.
(c) How many times longer does steel's nearest pin take than copper's? 36 ÷ 18 = 2.
Investigating with the rods
In the simulation above, Conduction is already chosen, with Block temperature at 250 °C and Rods lose energy to the air on.
- (Core) Predict the order, then press Play. The warm colours race along copper, and When each pin dropped lists the nearest pins at about 18 s (copper), 19 s (aluminium), 36 s (steel) and 380 s (glass).
- (Core) When the 1800 s run ends, the Copper card reads 5 / 5 but Glass is stuck at 1 / 5.
- (Core) Set Block temperature to 100 °C, which resets the run, then press Play again. Copper and aluminium still drop every pin; steel keeps most and glass keeps all five.
- (Supplement) With lattice vibrations alone, the glass colour fades to the room shade a few centimetres out, because the rod loses energy to the air almost as fast as it arrives.