What this topic covers
A scrapyard crane in Mombasa lifts a crushed car, drops it onto a lorry, and leaves the aluminium window frames in the heap untouched. The first half of syllabus 4.1 explains why.
Poles, attraction and repulsion (Core)
Every magnet has a north pole (N pole) and a south pole (S pole). A freely hanging magnet turns its N pole roughly northwards, because of the Earth's magnetic field (an extra fact, not needed for 0625).
- N facing N, or S facing S: they push apart. Like poles repel.
- N facing S: they pull together. Unlike poles attract.
A magnet also pulls on unmagnetised iron, with either pole, but never pushes it away. Attraction proves nothing, so repulsion is the only sure test: it needs a magnet on both sides. Magnetic forces act across a gap and get stronger as the gap closes.
Magnetic or non-magnetic? (Core)
A magnetic material is attracted by a magnet and can be magnetised. A non-magnetic material is neither.
| Magnetic | Non-magnetic |
|---|---|
| Iron, steel, nickel, cobalt | Copper, aluminium, brass, gold, glass, wood, plastic |
Most metals are on the non-magnetic side.
Induced magnetism (Core)
Hold an unmagnetised iron nail near a magnet's N pole and the nail becomes a magnet, even before contact: its magnetism is induced. The end facing the N pole gains an S pole, so opposite poles sit side by side and the nail is pulled in. Near the S pole the induced poles swap, and it is attracted again. The nail can then lift a second nail, forming a chain.
Soft iron and steel (Core)
| Soft iron | Steel | |
|---|---|---|
| Magnetising it | Very easy | Harder |
| After the magnet is removed | Loses almost all its magnetism | Keeps its magnetism |
| Kind of magnet | Temporary | Permanent |
| Typical job | Electromagnet core | Compass needle, bar magnet |
Where each kind is used (Core)
A permanent magnet needs no power supply. An electromagnet is a coil of wire, usually round a soft iron core, that is magnetic only while a current flows, so it can be switched on and off.
- Permanent: compasses, fridge door seals, cupboard catches, loudspeakers, microphones, small motors.
- Electromagnets: scrapyard cranes, electric door locks, MRI scanners, relays (topic 4.5.3) and electric bells.
When the crane's current stops, the soft iron core loses its magnetism and the scrap falls. A steel core would keep its grip.
Why magnets push and pull (Supplement)
Each magnet sits inside the other's magnetic field, and each field acts on the other magnet's poles. So the push or pull comes from the two fields acting on each other, which is why no contact is needed.
Worked example: sorting three bars (Core)
Three grey bars are tested against both poles of a labelled magnet. X is attracted by both. Y feels nothing. One end of Z is drawn towards the N pole but pushed away by the S pole.
(a) Identify each bar. Z is a magnet: only a magnet is repelled. X is magnetic but unmagnetised, such as iron. Y is non-magnetic, such as aluminium.
(b) Why is X attracted by both poles? Whichever pole comes near induces the opposite pole at X's near end.
(c) Which end of Z is N? The tested end was repelled by an S pole, so it is S. The far end is N.
Simulation tasks
In the simulation above, there is no iron or aluminium, so try induced magnetism with real nails.
- (Core) Choose Like poles facing (N to N) from the Set-up menu. The readout The two magnets shows Repel, and the force arrows point apart.
- (Core) Press Flip to reverse magnet 1. With an S pole now facing an N pole, the readout switches to Attract.
- (Core) Choose One magnet and drag the compass near each end. The needle is a tiny magnet: its N end points away from the magnet's N end and towards its S end.
- (Supplement) Choose Unlike poles facing (N to S): the Field lines join across the gap. Press Flip and the lines from the facing ends push away from each other.