What AQA 4.7.1.2 expects
Foundation and Higher candidates both need this, whether they sit GCSE Physics or Combined Science. No equation is attached. Plotting a field is not a required practical, but its method can be examined. You should be able to:
- define a magnetic field and name what it acts on
- draw a bar magnet's field, showing how its strength and direction vary
- describe how to plot a field using a compass
- explain why compasses show that the Earth's core is magnetic
The tesla is not needed until Higher tier 4.7.2.2.
What a magnetic field is
Around any magnet is its magnetic field: the space where a second magnet, or a piece of iron, steel, nickel or cobalt, would feel a force. On unmagnetised magnetic material that force is always a pull.
- Direction: picture a tiny, free N pole at the spot. The field points the way that pole would be pushed.
- Strength: greatest at the poles, falling quickly with distance from the magnet.
Drawing a bar magnet's field lines
A diagram that scores well shows:
- arrows that leave the N pole and enter the S pole
- lines packed tightly at the poles, where the field is strong, and spaced widely where it is weak
- smooth curves that never touch or cross, since a compass at any spot can point only one way
- lines on every side, including one straight out of each end
Worked example: plotting with a compass
Apparatus: a bar magnet, a small plotting compass, a pencil and plain paper.
- Draw round the magnet in the middle of the sheet, marking its N and S ends.
- Start with the compass next to the N pole; dot the paper at the tip of the needle's N end.
- Slide the compass on until the needle's S end sits over that dot, then make the next dot at its N end.
- Carry on until you reach the S pole or run out of paper.
- Join the dots in a smooth curve and arrow it from N to S.
- Start from other points near the N pole until lines surround the magnet.
Work away from steel and other magnets, which would deflect the needle. Iron filings (a common lab method, though not named in the AQA specification) give the shape at once but no direction.
The compass and the Earth's field
A compass needle is a small magnet free to spin. Far from other magnets, it settles with its N end northwards wherever it is taken. A magnet only lines up like that inside a magnetic field, so the Earth must produce a field of its own: evidence that its core is magnetic.
Unlike poles attract, and the needle's N end is pulled north, so the Earth's magnetic pole in the Arctic behaves as an S pole. The field a compass detects therefore points roughly north.
Near a bar magnet, the magnet's field is far stronger than the Earth's, so the needle follows the magnet.
Exploring fields in the simulation
In the simulation above, field lines are on from the start, with arrows leaving the magnet's N end and curving into its S end.
- Choose Where is it strongest? from Set-up: the compass begins 2 cm out from the S end, where Field strength shows about 770 μT. Under Position, pick Compass and set Across the paper to −12 cm: about 54 μT. Set Up the paper to 3 cm and Across the paper to 0 cm, roughly 2 cm from the side: only about 440 μT. These are model values.
- Choose Plotting with a compass, turn Field lines off and press Plot repeatedly. Each press dots where the needle's N end points, then moves the compass on until the S end of its needle covers that dot, as in steps 2 and 3. After eight presses the trail has curved round to the S end and the compass is blocked. Show the lines again and compare.
- Return to One magnet, pick Compass under Position, and set it 18 cm across and 13 cm up. Compass needle reads about 57°. Switch on Earth’s field (north is up the page): it swings to about 82°, nearly up the page, because out here the Earth's field is stronger than the magnet's. The × marks are neutral points, which AQA does not ask about.