On the bench
Up to four identical glass beakers stand on heatproof mats, each holding an equal volume of hot water. For each one you choose a wrapping (nothing, newspaper, bubble wrap, cotton wool, expanded polystyrene or aluminium foil), from one to four layers, and whether it has a card lid. The front of every wrapping is drawn cut away, so you can see the water, tinted from warm orange towards blue as it cools, and the liquid-in-glass thermometer standing in it. Above each thermometer a magnified window shows the scale around the end of the red column. A stopwatch runs in the corner, and one second on screen stands for half a minute of the experiment.
Reading a cooling curve
Each beaker has its own line on the temperature–time graph, and a dashed line marks room temperature. Every curve starts steep and then levels off. Water far above the room passes energy to the air, the bench and the mat quickly; as the gap closes, the transfer slows, so the water creeps towards room temperature without ever going below it. Use the gradient tool to compare the slope early in a run with the slope near the end.
Why wrapping slows the cooling
Energy leaves the water in four ways. It is conducted through the glass, carried off by moving air, given out as infrared radiation and taken away by water that evaporates from the surface. Cotton wool, bubble wrap and polystyrene all hold plenty of still air, which is a very poor conductor, so these materials have a low thermal conductivity. Extra layers make a thicker barrier and a slower transfer, yet even four layers of polystyrene only slow the cooling; they never stop it. Foil works differently: aluminium conducts well, but a shiny surface gives out very little infrared. A lid matters more than most people expect, because the open surface of hot water loses a lot of energy through evaporation.
Doing the required practical
Switch Mode to Practical. Readings go into the results table every minute, to the nearest 0.5 °C, which is how you would read a thermometer marked in whole degrees. Small random errors appear, as they would in a real lab, and in most runs one reading is written down wrongly. The table marks any reading that does not fit the trend, so you can practise spotting anomalies. Press Repeat after each run to collect three sets of results, then compare the mean drops and their uncertainties.
To see the three ways energy moves in more detail, try the conduction, convection and radiation simulation. For why water stores so much energy for each degree, open the specific heat capacity simulation.