What this topic covers
Give equal masses of water and cooking oil the same amount of energy, and the oil's temperature rises roughly twice as much. Specific heat capacity explains why.
Temperature and internal energy (Core)
Heating an object transfers energy to it. When its temperature rises, its internal energy, the energy of all its particles, has increased. A pot of rice at 90 °C has more internal energy than the same pot at 30 °C.
Temperature and particles (Supplement)
Particles are always moving, at a range of speeds. A rise in temperature means that the average kinetic energy of all the particles has increased. In a solid they vibrate more vigorously; in a liquid or a gas they move around faster.
Specific heat capacity (Supplement)
Specific heat capacity, , is the energy needed per unit mass per unit rise in temperature: the joules that warm 1 kg of a material by 1 °C. Learn the equation:
Here is the energy transferred in J, the mass in kg and the temperature change in °C, so is in J/(kg °C) (or J/(g °C)).
Water's value, about 4200 J/(kg °C), is unusually high; aluminium's is about 900 and copper's about 390. With equal energy, 1 kg of copper heats up more than ten times as much as 1 kg of water. Storing so much energy per kilogram per degree makes water ideal for central heating and hot-water bottles.
Worked example 1: a water heater (Supplement)
An electric hot-water tank in a flat in Amman warms 90 kg of water from 12 °C to 57 °C. Find the energy gained, using = 4200 J/(kg °C).
Answer: about J (17 MJ).
Worked example 2: a lab result (Supplement)
A 40 W heater warms a 1.00 kg aluminium block for 600 s, and the thermometer rises from 21.0 °C to a peak of 46.0 °C.
Answer: 960 J/(kg °C), above the usual 900 J/(kg °C). Some energy escaped to the surroundings instead of warming the block, so came out too small and too large.
Measuring specific heat capacity (Supplement)
A solid. Weigh a metal block that has two holes. Fit an immersion heater into one and a thermometer into the other, with a few drops of oil around the bulb for good thermal contact, and wrap the block in insulation. Note the starting temperature and switch on. Measure the energy with a joulemeter, or with a voltmeter, an ammeter and a stopwatch using . After a few minutes switch off, but go on reading the thermometer until it stops rising, and note the peak.
A liquid. Find its mass by weighing an insulated container, such as a polystyrene cup, empty and then filled. Keep the heater fully covered, stir gently throughout, and take the same readings.
Insulation, a lid and stirring all improve the result.
Simulation tasks
In the simulation above, the sample is a 1.00 kg Aluminium block, Lagged, with a 50 W heater and the Heater timer at 10 min. The heater is already on (Heater on), and Results gains a reading every minute.
- (Core) Press Play. As the temperature climbs, so does the Internal (thermal) energy of the aluminium block.
- (Supplement) At 600 s the timer cuts the heater after 30000 J, yet the temperature creeps up a little more. When the run ends, the box headed From the first reading and the highest temperature uses the peak of 52.2 °C to give 932 J/(kg °C), 3.5% above the accepted 900.
- (Supplement) Set Heat a second sample beside it to Water and press Play again. With equal energy, by switch-off the aluminium has warmed by about 32 °C, the water by only about 7 °C.
- (Supplement) Set Insulation to None and run again: that box now shows 1030 J/(kg °C). The ideal No losses setting gives 901.