What this simulation shows
A micrometer screw gauge reads small lengths to 0.01 mm, a tenth of a school vernier calliper's least count. It is the tool for the diameter of a wire, the thickness of a sheet of paper or the size of a ball bearing. Here you turn the thimble yourself, by dragging it, with the slider or the arrow keys, and the spindle winds towards the anvil. The ratchet closes the jaws gently and clicks when they grip.
Below the instrument, a close-up shows the sleeve and thimble at a size you can read on a phone. Every line in it is placed from the reading itself, so the division that glows on the datum line really is the one the gauge is showing.
Pitch and least count
Inside the barrel is a fine screw. One complete turn of the thimble moves the spindle by one pitch, which is 0.5 mm on the usual school instrument. The bevelled edge of the thimble is marked with 50 equal divisions, so turning it by one division moves the spindle by a fiftieth of the pitch.
Some gauges use a 1 mm pitch with 100 divisions instead. Switch the instrument in the controls and the least count stays the same.
Taking a reading
- Look at the sleeve. Find the last mark the thimble edge leaves uncovered. Whole millimetres are above the datum line and half millimetres are below it. This gives the main scale reading.
- Look at the thimble. Read the division sitting level with the datum line. This is the circular scale reading.
- Multiply the division by the least count and add it on.
The half-millimetre mark catches many people out. If one is showing after the last whole millimetre, add 0.5 mm before the thimble value. A circular reading close to 0 with a mark just appearing, or one in the high 40s with a mark just hidden, are the readings to check twice.
Zero error
Before measuring, close the empty jaws with the ratchet. On a perfect gauge the thimble zero stops on the datum line. If it stops below the line, the instrument already reads a little above zero, so every result comes out too big: a positive zero error. If the thimble turns past zero and stops with its zero above the line, it reads too little: a negative zero error, found by counting divisions from the line up to the zero.
So a positive error is taken away and a negative one ends up added. In the Punjab Class 9 book the rule is given in words, with the datum line called the horizontal line: zero below that line, subtract the error; zero above it, add the error. Whenever the gauge has a zero error, the readout cards show this subtraction with its signs.
Very thin objects
A single sheet of paper is only about ten least counts thick. Stacking many sheets, measuring the stack and dividing by the number of sheets gives a far more precise value for one sheet.
Practice mode
In Practice the object and its size are chosen at random, and some gauges come with a zero error. Press Zero check (the 0 button under the stage) to read the closed jaws, then press it again to measure. Type the corrected reading and the feedback names your slip: a missed half mark, a forgotten or reversed zero error, the wrong least count or a misread thimble.