Skip to content

Cambridge IGCSE Physics (0625) · Light and the electromagnetic spectrum

Thin lenses

3.2.3

A converging lens brings a parallel beam to the principal focus; a diverging lens spreads it out. Ray diagrams find the image: enlarged, same size or diminished; upright or inverted; real or virtual. Supplement: virtual-image ray diagrams, the magnifying glass and lenses for long and short sight.

Loading simulation…

Symbols match your course. Open the full lenses and ray diagrams simulation for more presets and teacher tools.

What this topic covers

A parallel beam meets a lens (Core)

The principal axis runs through the lens centre, at right angles to the lens. For rays parallel to this axis:

  • a converging lens, thickest in the middle, bends them inwards to meet beyond it at the principal focus (focal point) F;
  • a diverging lens, thinnest in the middle, bends them outwards, as if spreading from F on the side the light came from.

The focal length f is the distance from the optical centre to F; there is an F this far away on each side.

Three groups of words (Core)

Use one term from each group: enlarged, same size or diminished; upright or inverted; real or virtual.

A real image sits where rays of light truly cross, so a screen there catches it. A virtual image is where spreading rays, extended backwards as dashed lines, seem to come from. No light reaches it, so no screen can show it.

Worked example: a real image (Core)

A converging lens has a focal length of 10 cm. An object 3.0 cm tall stands 25 cm in front of it. Locate and describe the image.

  1. Scale. At half size (1 cm on the page for 2 cm), draw the lens as a vertical line, mark F at 5.0 cm and 2F at 10.0 cm on each side, and draw the object 12.5 cm away, 1.5 cm tall.
  2. Ray 1. From the tip, parallel to the axis, then through F beyond the lens.
  3. Ray 2. From the tip, straight through the optical centre.
  4. Crossing. The rays meet about 8.3 cm beyond the lens, 1.0 cm under the axis. Ray 3 (through the near F, then parallel) checks it.
  5. Scale up: about 17 cm from the lens, 2.0 cm tall.

Answer: between F and 2F, opposite the object; diminished (2.0 cm against 3.0 cm), inverted (below the axis) and real (the rays cross there).

Moving the object

Use this table to check your own ray diagrams. The syllabus does not list these object positions; the last column says which part of it covers each kind of diagram. Every row uses a converging lens except the last.

ObjectImage: size, way up, typeWhere it formsSyllabus
Beyond 2Fdiminished, inverted, realopposite side, between F and 2FCore
At 2Fsame size, inverted, realopposite side, at 2FCore
Between F and 2Fenlarged, inverted, realopposite side, beyond 2FCore
At Fno imagenone: the rays emerge parallelnot listed
Nearer than Fenlarged, upright, virtualobject's side, further out than the objectSupplement
Diverging lens, any distancediminished, upright, virtualobject's side, between F and the lensbeyond the syllabus

Supplement: the magnifying glass

With the object nearer than F, the rays still diverge after the lens. Extended backwards as dashed lines, they meet on the object's side, further out than the object: an enlarged, upright, virtual image. A magnifying glass is one converging lens held so that the object, such as small print on a medicine packet, is inside F.

Supplement: correcting eyesight

  • Short sight: distant objects look blurred because the eye focuses their light in front of the retina. A diverging spectacle lens spreads the rays slightly first, moving the focus back onto the retina.
  • Long sight: near objects look blurred because their light would focus behind the retina. A converging lens bends the rays inwards a little. They still spread out after it, but less, so the eye can now bring them to a focus on the retina.

On the optical bench

In the simulation above, the Converging lens starts with Focal length 10 cm, Object distance 30 cm and Object height 5 cm. Rays bend only at the lens symbol drawn over the glass. The image is Real, inverted, diminished, 15 cm beyond the lens and 2.5 cm tall.

  1. Set Object distance to 25 cm and Object height to 3 cm (the worked example): the image is 16.7 cm away and 2 cm tall, on a screen.
  2. Supplement: pick Magnifier from Set-ups. No screen appears: dashed lines lead back to a virtual, upright, enlarged image 16.8 cm away on the object's side.
  3. Supplement: try Short sight (a diverging lens) and Long sight, reading the note below the readouts.

The Magnification and lens-equation readouts are Beyond IGCSE.

Common mistakes

  • Describing an image with only one or two terms. Give one from each group: its size (enlarged, same size or diminished), which way up it is (upright or inverted) and whether it is real or virtual.
  • Measuring the focal length from the object, or from the edge of the lens. It is measured between the lens's optical centre and the principal focus.
  • Drawing the ray that starts parallel to the principal axis so that it passes through F on the object's side. After a converging lens it goes through F on the far side.
  • Saying a virtual image can be caught on a screen if the screen is put in the right place. No light reaches a virtual image, so a screen never shows it.
  • (Supplement) Drawing the backward extensions to a virtual image as solid lines. Draw them dashed, because no light travels along them.
  • (Supplement) Swapping the spectacle lenses. Short sight needs a diverging lens, because the eye focuses light from distant objects in front of the retina; long sight needs a converging lens.

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A beam of light, with every ray parallel to the principal axis, is directed at a thin converging lens.

    1. (a)State what is meant by the principal focus of the lens.

      2 marks
      Show the answer

      Answer: The point on the principal axis where rays that were parallel to the axis meet after passing through the lens.

      Marking points

      • point on the principal axis
      • where rays parallel to the axis meet / converge after passing through the lens
    2. (b)State what is meant by the focal length of the lens.

      1 mark
      Show the answer

      Answer: How far the principal focus is from the optical centre (the centre) of the lens.

      Marking points

      • distance between the optical centre (centre of the lens) and the principal focus
    3. (c)The converging lens is replaced by a thin diverging lens. Describe what happens to the beam.

      2 marks
      Show the answer

      Answer: The rays spread out (diverge) after the lens. They appear to come from the principal focus on the side of the lens where the light enters.

      Marking points

      • rays spread out / diverge
      • appear to come from the principal focus on the same side as the incoming light
  2. 2.An object 4.0 cm tall stands on the principal axis, 12 cm from a thin converging lens of focal length 8.0 cm.

    1. (a)Describe how a pair of rays, both leaving the top of the object, can be drawn to locate the image.

      3 marks
      Show the answer

      Answer: One ray runs parallel to the principal axis as far as the lens, then through the principal focus on the far side. The other passes through the optical centre and keeps its direction. The top of the image is where the two rays cross.

      Marking points

      • ray parallel to the principal axis, then through the principal focus on the far side
      • ray through the centre of the lens, undeviated
      • top of the image where the rays cross
    2. (b)On an accurate diagram the rays cross 24 cm beyond the lens, 8.0 cm below the principal axis. Describe the image.

      3 marks
      Show the answer

      Answer: Real, inverted and enlarged.

      Marking points

      • real
      • inverted
      • enlarged
    3. (c)A screen is placed 24 cm beyond the lens. State what is seen on the screen and explain why.

      2 marks
      Show the answer

      Answer: A sharp, upside-down image of the object, because rays of light from the object really meet at the screen.

      Marking points

      • a sharp / focused image (of the object)
      • light rays actually meet there / the image is real
    4. (d)The object is moved to 16 cm from the lens. State where the image now forms and compare its size with the object.

      2 marks
      Show the answer

      Answer: 16 cm beyond the lens, at 2F on the opposite side. It is the same size as the object.

      Marking points

      • 16 cm beyond the lens / at 2F on the opposite side
      • same size as the object
  3. 3.A student examines a postage stamp through a converging lens with a 10 cm focal length, used as a magnifying glass.

    1. (a)(Supplement) State how far the stamp must be from the lens.

      1 mark
      Show the answer

      Answer: Less than 10 cm: closer to the lens than the principal focus.

      Marking points

      • less than 10 cm / between the principal focus and the lens
    2. (b)(Supplement) Describe the image of the stamp that the student sees.

      3 marks
      Show the answer

      Answer: Virtual, upright and enlarged.

      Marking points

      • virtual
      • upright
      • enlarged
    3. (c)(Supplement) Explain how the position of this image is found on a ray diagram.

      2 marks
      Show the answer

      Answer: The rays leaving the lens are diverging, so they are extended backwards with dashed lines. The image is where these extensions meet, on the stamp's side of the lens.

      Marking points

      • rays diverge after the lens and are extended backwards (dashed)
      • image where the extensions meet, on the same side as the object
    4. (d)Explain why this image cannot be formed on a screen.

      1 mark
      Show the answer

      Answer: No light actually reaches the place where the image appears to be; the rays only seem to come from it.

      Marking points

      • no light reaches / meets there; rays only appear to come from it
  4. 4.A student who is short-sighted can read a book clearly but sees a distant scoreboard as a blur.

    1. (a)(Supplement) Explain why the distant scoreboard looks blurred.

      2 marks
      Show the answer

      Answer: The eye brings light from the distant scoreboard to a focus in front of the retina. By the time the rays reach the retina they have spread apart again, so no sharp image forms there.

      Marking points

      • light from a distant object focuses in front of the retina
      • so the image on the retina is not sharp
    2. (b)(Supplement) State the type of lens that corrects short sight and describe its effect on the light.

      2 marks
      Show the answer

      Answer: A diverging lens. It spreads the rays out slightly before they enter the eye, so the eye brings them to a focus on the retina.

      Marking points

      • diverging lens
      • spreads the rays slightly before the eye so they focus on the retina
    3. (c)(Supplement) Another student is long-sighted. State the type of lens that corrects long sight and explain how it helps.

      3 marks
      Show the answer

      Answer: A converging lens. Without it, light from a near object would come to a focus behind the retina. The lens bends the rays inwards, so they diverge less as they enter the eye and the eye can focus them on the retina.

      Marking points

      • converging lens
      • uncorrected, light from a near object would focus behind the retina
      • lens bends the rays inwards (they diverge less) before they enter the eye, so they focus on the retina

Quick check

6 questions

  1. 1.A beam of rays parallel to the principal axis passes through a thin converging lens. Where do the rays meet?
  2. 2.A converging lens has a focal length of 10 cm. An object stands 30 cm from it. Which describes the image?
  3. 3.(Supplement) Which spectacle lens corrects short sight, and why?
  4. 4.What is the focal length of a lens?
  5. 5.A parallel beam of light passes through a thin diverging lens. What happens to the beam?
  6. 6.(Supplement) A converging lens is used as a magnifying glass. Where must the object be?