Spec point 4.6.1.1: what you need
Every AQA student is examined on this spec point, on both tiers, whether the course is GCSE Physics or Combined Science. Nothing in it needs an equation. By the exam you should be able to:
- describe how a transverse wave differs from a longitudinal wave
- name AQA's two examples: ripples on water are transverse, and sound travelling through air is longitudinal
- describe evidence that, for ripples and for sound, the wave moves forward while the water or air stays where it was.
Amplitude, wavelength and are on the properties of waves page (spec point 4.6.1.2).
One question sorts every wave
A wave carries energy away from its source. Water, air or a rope is the medium: its particles pass the disturbance on, each one oscillating about its own fixed point. To name the type, compare two directions: the way each particle moves, and the way the energy goes.
| Compare | Transverse | Longitudinal |
|---|---|---|
| How each particle oscillates | Perpendicular (at 90°) to where the energy goes | Forwards and backwards, parallel to where the energy goes |
| Features to label | Crests (peaks) and troughs | Compressions and rarefactions |
| Examples for AQA | Water ripples; light and every other electromagnetic wave; a pulse sent along a skipping rope | Sound in air; a slinky pushed and pulled along its own length |
In a compression, particles are squeezed closer together than usual, so the pressure there is slightly raised. In a rarefaction they are spaced further apart and the pressure dips a little. The particles are still there: a rarefaction is not a gap. A loudspeaker cone makes this pattern by moving out and in, again and again.
Evidence that only the wave travels
An exam answer here needs two things: what you would observe, and what that observation proves.
- Ripples. Float a table-tennis ball in a ripple tank, or watch a gull sitting on a calm harbour. Each ripple lifts and lowers it, but it stays over almost the same spot. If the water were flowing towards the far side, the ball would be swept along too. So the ripples carry energy across the surface, not water.
- Sound. A radio in the corner of a classroom is heard at the back, yet nobody there feels a breeze from it. A light strip of tissue paper hung near a loudspeaker playing a loud, deep note flutters forwards and backwards along the line the sound travels, but is not pushed away. The air only oscillates as the energy passes through it.
Worked example: the ripple arrives, the leaf stays
A pebble lands in a still pond and sends out ripples at 0.40 m/s. A leaf floats 3.0 m from where the pebble landed.
(a) How long is it before the leaf starts to bob?
Given: m and m/s. Equation: , which you must recall (spec 4.5.6.1.2), so . Substitution: . Answer: s.
(b) In the first 30 s, how far across the pond does the leaf travel?
On a windless day, almost no distance: it rises and falls about the same point. The first ripple moves m in that time, so the energy goes far beyond the leaf while the water stays put.
Using the simulation
In the simulation above, Transverse is selected, the source vibrates at 1.0 Hz with an Amplitude of 0.20 m, and the Wave speed is 2.0 m/s. Track is already on, so press Play and watch the highlighted particle, 1.0 m from the source. It stays still until the wave front arrives: the displacement–time graph is flat for the first 0.50 s, which is 1.0 m ÷ 2.0 m/s. After that it moves only up and down across the dashed rest position line, while the diamond marker rides one crest along the chain.
Now pick Longitudinal under Type of wave. The same particle slides forwards and backwards along the chain, either side of the short dotted line that marks its own rest position. The stage marks compressions C and rarefactions R, and because Shade where particles crowd together is already on, each compression shows as a more strongly shaded band. Follow one C as it travels: no particle goes with it. To check another particle, tap it on the stage or move the Rest position slider under Tracked particle.