Hot, cold and temperature
Chilled sherbet feels cold and a fresh paratha hot, but touch gives no number. Temperature is the degree of hotness or coldness of a body.
Temperature also decides the direction in which thermal energy flows: from the hotter of two bodies in contact to the colder one, until both are equally hot.
What temperature means for molecules
In molecular terms, temperature is a measure of the average kinetic energy of a body's molecules. Warm a body and its molecules speed up, so this average and the temperature both rise. The lowest temperature possible, about −273 °C, is absolute zero, where the molecules have the least kinetic energy they can have.
Being an average, temperature does not depend on the amount of matter: a spoonful and a full degchi of boiling water are both at 100 °C.
Temperature is a base quantity. Its SI unit is the kelvin (K); the degree Celsius (°C) is used in daily life.
Heat: energy on the move
Heat is energy that moves from one body to another because they are at different temperatures. Being energy, it has the SI unit joule (J).
The word is used only for energy while it is moving. Rain is rain while it falls; once collected in a tank, it is simply water. Likewise, heat that has flowed into a body is no longer heat: it is part of the body's internal energy.
Internal energy
Each molecule moves, so it has kinetic energy, and its neighbours attract it, so it also has potential energy. Internal energy is the kinetic energy and the potential energy of all the molecules of a body, added together. It is measured in joules.
Heat flowing in raises the internal energy; heat flowing out lowers it. A rise in a body’s temperature means a rise in its internal energy.
| Temperature | Heat | Internal energy | |
|---|---|---|---|
| Describes | how hot one body is | a transfer between two bodies | the molecular energy of one body |
| SI unit | kelvin (K) | joule (J) | joule (J) |
Worked example: a cup and a bucket
Problem. A cup holds 0.20 kg of water at 80 °C. A bucket holds 10 kg of water at 30 °C. (a) Where do the molecules move faster on average? (b) Which has more internal energy? (c) The cup is stood in the bucket. Which way does heat flow, and when does it stop?
(a) In the cup. It is hotter, so its molecules have the greater average kinetic energy.
(b) The bucket. It holds
times as much water, so 50 times as many molecules. Together they have far more energy, though each has slightly less on average.
(c) From the cup into the bucket, because the cup is hotter. Temperature sets the direction, not internal energy. It stops when both reach the same temperature.
Worked example: adding heat
Problem. The molecules of a small brass block have a total kinetic energy of 750 J. Their total potential energy, measured from a chosen zero, is 250 J. Pressed against a hotter iron plate, the block gains 180 J of heat, and no energy escapes. Find its internal energy before and after.
Its molecules now vibrate more vigorously, so its temperature rises too. Potential energy, like height, is counted from a chosen zero, so both totals depend on that choice; the rise of 180 J does not.
Watching energy flow in
In the simulation above, the box starts as a cold Solid at 24 K. This Temperature is on a model scale. Like the kelvin scale, it starts at absolute zero and is proportional to the particles’ average kinetic energy, but it is not the temperature of a real substance. The Internal energy card reads "= sum of KE and PE of the molecules".
- Press Heat. The stage shows "Heater on · 20 units/s". Temperature and Average kinetic energy rise together, and Internal energy gains about 20 units each second: the energy transferred becomes internal energy.
- After about 10 seconds, press Heat again to switch the heater off. Nothing enters or leaves the sealed box, so Internal energy stays almost constant.
- Press Cool. Energy flows out, and those same three readings fall.
- Press Reset, then Heat, and keep heating. While the State card shows Changing state with "melting" under it, the Temperature against time line flattens, yet Internal energy on the Energy against time graph keeps climbing, mostly as Total PE. Temperature and internal energy are not the same. (Changes of state come in Class 10.)