Skip to content

Cambridge IGCSE Physics (0625) · Light and the electromagnetic spectrum

Communication and digital signals

3.3

Core: links with artificial satellites mainly use microwaves, through low-orbit or geostationary satellites. Supplement: why phones and Wi-Fi use microwaves, Bluetooth radio waves and optical fibres visible light or infrared; analogue and digital signals, and why digital signalling is better.

Loading simulation…

Symbols match your course. Open the full electromagnetic spectrum simulation for more presets and teacher tools.

What this topic covers

A herder on the Mongolian steppe phones home by satellite, while a flat in Manchester gets broadband through a strand of glass. Each link rides on an electromagnetic wave chosen for the job (syllabus 3.3).

  • Low-orbit satellites circle close to the Earth. Each crosses the sky within minutes, so a phone network needs many of them. Some satellite phones use them.
  • Geostationary satellites circle above the equator, turning the same way as the Earth. Each stays above one spot, so a rooftop dish never needs to move. Satellite TV and some satellite phones use them.

Beyond the syllabus: microwaves cross the atmosphere easily, and a dish aims them in a narrow beam. A low orbit lies a few hundred to about two thousand kilometres up, and one lap takes roughly 90 to 130 minutes. A geostationary orbit lies about 36 000 km up, and one lap takes a day.

Phones, Wi-Fi and Bluetooth (Supplement)

Mobile phones and Wi-Fi rely on microwaves for two reasons. Some walls let them through, so a phone keeps its signal indoors. Their short wavelengths, at most a few tens of centimetres, mean the aerial that sends and receives them can be small.

Bluetooth, linking earbuds to a phone, counts as radio waves in this syllabus. The signal reaches through a wall into the next room, but every wall leaves it weaker.

Worked example: Wi-Fi and radio wavelengths (Supplement)

A router sends Wi-Fi at 5.0×1095.0 \times 10^9 Hz, and a car radio picks up a station at 1.0×1081.0 \times 10^8 Hz. Using v=3.0×108v = 3.0 \times 10^8 m/s, find each wavelength.

λWi-Fi=vf=3.0×1085.0×109=0.060 m\lambda_\text{Wi-Fi} = \frac{v}{f} = \frac{3.0 \times 10^8}{5.0 \times 10^9} = 0.060\ \text{m} λradio=3.0×1081.0×108=3.0 m\lambda_\text{radio} = \frac{3.0 \times 10^8}{1.0 \times 10^8} = 3.0\ \text{m}

Answer: 6.0 cm and 3.0 m.

Beyond the syllabus: a simple aerial is often a quarter of a wavelength long. That makes 0.060÷4=0.0150.060 \div 4 = 0.015 m for the Wi-Fi, small enough to fit inside a router or phone, while the car needs a rod of 3.0÷4=0.753.0 \div 4 = 0.75 m.

Light and infrared in glass (Supplement)

Cable TV and fast broadband reach homes along optical fibres as flashes of visible light, or of infrared just beyond red. Glass lets these wavelengths through with very little loss, and they can carry data at a very high rate. Beyond the syllabus: their frequencies are so high that the flashes can be extremely short and close together.

Analogue and digital (Supplement)

Analogue signalDigital signal
Valuesany value in a range, changing smoothlyonly a few fixed values, usually two: 0 and 1
Shapea continuous wavea train of on–off pulses

Sound, either way. A microphone turns sound into a voltage that rises and falls with the air pressure: an analogue signal. It can be sent like that, or measured thousands of times a second and each value sent as a binary number: a digital signal.

Why digital is better.

  • More data: digital systems can send data at a higher rate.
  • Longer range: any signal weakens over distance and picks up random noise. A regenerator only has to decide whether each pulse is a 0 or a 1, so it can rebuild a digital signal exactly as sent. Amplifying an analogue signal amplifies its noise too, so noise builds up.

In the simulation above, which opens on Orange light (600 nm), analogue and digital signals do not appear.

  1. (Core) Press the Infrared button under the stage, then Microwave. The marker moves to Microwave oven (12 cm), and a note under the dangers list says satellite links mainly use microwaves.
  2. (Supplement) Open the Supplement box below that note for why phones and wireless internet use microwaves.
  3. (Supplement) Press Radio to reach FM radio (3.0 m), whose Frequency card matches the car radio above. Its Supplement box covers Bluetooth.
  4. (Supplement) Choose TV remote control (940 nm) from Jump to an example and open the Supplement box on optical fibres.
  5. (Supplement) Move the Wavelength slider to 6.0 cm. The Frequency card shows 5.0 × 10⁹ Hz, the Wi-Fi value worked out above.

Common mistakes

  • Saying that satellites are contacted mainly with radio waves. In this syllabus, links with artificial satellites mainly use microwaves.
  • Thinking that every satellite phone uses a geostationary satellite. Some satellite phones work through satellites in low orbits; direct broadcast satellite TV uses geostationary ones.
  • (Supplement) Writing microwaves for Bluetooth. The syllabus answer is radio waves, which reach through walls but lose strength in each one, even though Bluetooth's 2.4 GHz is often counted as a microwave frequency.
  • (Supplement) Saying that microwaves pass through all walls. They get through some walls, but thick concrete and metal can block them, which is why a phone can lose its signal inside a lift.
  • (Supplement) Claiming that digital signals travel faster than analogue ones. Both move at the same speed; digital is better because more data can be sent each second and the signal can be regenerated accurately.
  • (Supplement) Thinking that an amplifier cleans up an analogue signal. It boosts the noise as well as the signal, so the noise grows along a long route; a digital signal can be rebuilt exactly.

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A geologist working in a remote part of the Andes carries a satellite phone. The camp has a television that receives its programmes from a satellite through a dish, and a radio that picks up a local station.

    1. (a)State which region of the electromagnetic spectrum is mainly used to send signals to and from artificial satellites.

      1 mark
      Show the answer

      Answer: Microwaves.

      Marking points

      • microwaves
    2. (b)Name the two types of artificial satellite used by satellite phones.

      2 marks
      Show the answer

      Answer: Low-orbit satellites and geostationary satellites.

      Marking points

      • low-orbit (low Earth orbit) satellites
      • geostationary satellites
    3. (c)State which of these two types is used for direct broadcast satellite television.

      1 mark
      Show the answer

      Answer: Geostationary satellites.

      Marking points

      • geostationary
    4. (d)The television is switched between channels with a remote control. Name the region of the electromagnetic spectrum that the remote control uses.

      1 mark
      Show the answer

      Answer: Infrared.

      Marking points

      • infrared
    5. (e)Name the region of the electromagnetic spectrum that carries the local radio station's broadcasts.

      1 mark
      Show the answer

      Answer: Radio waves.

      Marking points

      • radio waves
  2. 2.A student in Singapore connects a laptop to the internet by Wi-Fi at a frequency of 2.4 × 10⁹ Hz. Music from the laptop plays through a speaker linked to it by Bluetooth.

    1. (a)(Supplement) State the region of the electromagnetic spectrum used for wireless internet.

      1 mark
      Show the answer

      Answer: Microwaves.

      Marking points

      • microwaves
    2. (b)(Supplement) Give two reasons why this region is used for mobile phones and wireless internet.

      2 marks
      Show the answer

      Answer: Some walls let microwaves through, so the signal reaches indoors, and their short wavelength means a small aerial is enough to send and receive them.

      Marking points

      • get through (penetrate) some walls
      • aerial can be short (small)
    3. (c)(Supplement) Calculate the wavelength of the Wi-Fi signal.

      3 marks
      Show the answer

      Answer: λ = v ÷ f = 3.0 × 10⁸ ÷ 2.4 × 10⁹ = 0.13 m (0.125 m)

      Marking points

      • correct rearrangement: λ = v ÷ f
      • 3.0 × 10⁸ ÷ 2.4 × 10⁹ seen
      • 0.13 m (accept 0.125 m or 12.5 cm)
    4. (d)(Supplement) State the region of the electromagnetic spectrum used by Bluetooth. Describe what happens to a Bluetooth signal when it passes through a wall.

      2 marks
      Show the answer

      Answer: Radio waves. The signal gets through the wall but comes out weaker.

      Marking points

      • radio waves
      • gets through, but is weaker on the far side
  3. 3.High-speed broadband and cable television reach a block of flats in Cairo through optical fibres made of glass.

    1. (a)(Supplement) Name the two regions of the electromagnetic spectrum that can be used to carry signals along optical fibres.

      2 marks
      Show the answer

      Answer: Visible light and infrared.

      Marking points

      • visible light
      • infrared (short wavelength)
    2. (b)(Supplement) Explain why these two regions are suitable for sending data along glass fibres.

      2 marks
      Show the answer

      Answer: Glass is transparent to these wavelengths, so very little of the signal is absorbed and it stays strong. These waves can also carry data at a high rate.

      Marking points

      • glass lets them through (is transparent to them) with little absorption
      • they can carry data at a high rate (high rate of data transmission)
    3. (c)Inside one of the flats, a television is controlled from across the room without any cable. Name the region of the electromagnetic spectrum used for this short-range link.

      1 mark
      Show the answer

      Answer: Infrared.

      Marking points

      • infrared
  4. 4.In a studio in Lagos, a microphone picks up a singer's voice and produces an analogue signal. The sound is then sent along a long cable to a radio station in another city.

    1. (a)(Supplement) Describe the difference between an analogue signal and a digital signal.

      2 marks
      Show the answer

      Answer: An analogue signal varies continuously and can have any value within a range. A digital signal has only a few set values, usually two (0 and 1, or off and on).

      Marking points

      • analogue: varies continuously / can take any value (in a range)
      • digital: only a few set values, e.g. two (0 and 1, off and on)
    2. (b)(Supplement) State whether the sound can be sent as an analogue signal, as a digital signal or in either form.

      1 mark
      Show the answer

      Answer: In either form.

      Marking points

      • either (analogue or digital)
    3. (c)(Supplement) Along the cable the signal becomes weaker and picks up noise. Explain why a digital signal can be sent over a greater distance than an analogue signal.

      3 marks
      Show the answer

      Answer: A digital signal can be regenerated along the route. The regenerator only has to tell whether each pulse is a 0 or a 1, so it can remove the noise and rebuild the signal accurately. When an analogue signal is amplified, the noise is amplified too, so the noise builds up.

      Marking points

      • digital signal is regenerated (by regenerators / repeaters) along the route
      • only needs to tell 0 from 1, so noise is removed / signal restored accurately
      • amplifying an analogue signal also amplifies the noise (noise builds up)
    4. (d)(Supplement) State one other benefit of digital signalling.

      1 mark
      Show the answer

      Answer: Data can be transmitted at a higher rate.

      Marking points

      • more data sent per second (higher data rate)

Quick check

6 questions

  1. 1.Which region of the spectrum carries most signals to and from artificial satellites?
  2. 2.(Supplement) Which region of the spectrum does the syllabus give for Bluetooth?
  3. 3.(Supplement) Why are microwaves used for mobile phones?
  4. 4.(Supplement) Which waves carry broadband signals along optical fibres?
  5. 5.(Supplement) Which statement describes a digital signal?
  6. 6.(Supplement) Why can a digital signal be sent further than an analogue signal?