Distance–time graphs for AQA
Spec point 4.5.6.1.4 asks you to plot distance–time graphs from data, explain what each part of the line shows, and use the slope to find speeds. This is on both tiers. Finding the speed of an accelerating object with a tangent is Higher tier only.
The link to matters here. That equation is one you must remember, and finding the slope of a distance–time graph is the same calculation done on a graph: distance divided by time.
What each shape tells you
Time always goes along the horizontal axis and distance up the vertical axis. Read the shape of the line, not just its height.
| Shape of the line | What the object is doing |
|---|---|
| Flat (horizontal) | Not moving: the distance stays the same as time passes |
| Straight and sloping upwards | Moving at a steady speed |
| Steeper straight line | A higher steady speed |
| Curving upwards, getting steeper | Speeding up (accelerating) |
| Curving over, getting flatter | Slowing down (decelerating) |
The gradient is the speed
For any straight section, pick two points as far apart as you can. Work out how much the distance changes between them and how much the time changes. Then divide:
Using points that are far apart makes your reading errors a smaller fraction of the answer.
Worked example 1: a cycle ride with a stop
A cyclist's distance–time graph has three straight sections:
- 0 s to 30 s: the line rises from 0 m to 180 m.
- 30 s to 50 s: the line is flat at 180 m.
- 50 s to 90 s: the line rises from 180 m to 300 m.
Given: first section, change in distance = 180 m, change in time = 30 s
Equation: (the gradient)
Substitution:
Answer:
The flat section shows the cyclist stopped for 20 s, perhaps at a level crossing. In the last section the gradient is . That line is less steep, so the cyclist was slower.
For the whole ride, the average speed is to 2 significant figures. The stop counts as part of the time.
Higher tier: speed at one moment on a curve
When the line curves, the speed is changing, so there is no single gradient. To find the speed at one particular time:
- Mark the point on the curve at that time.
- Use a ruler to draw a tangent: a straight line that touches the curve at that point and follows its slope there.
- Make the tangent long, then find its gradient using two points on the tangent, not on the curve.
Worked example 2. A car's distance–time graph curves upwards. A tangent drawn at 6.0 s passes through (4.0 s, 0 m) and (10.0 s, 36 m).
Equation: speed = gradient of the tangent
Substitution:
Answer: at 6.0 s
Drawing your own graph from measurements
Put time on the x-axis and distance on the y-axis, each with a label and a unit. Choose scales so your points use at least half of the grid. Plot each point as a small neat cross. Then draw one line of best fit: a ruled straight line if the points lie in a line, or a smooth curve if they do not. Never join the dots with short straight pieces.
Using the simulation
In the simulation above, choose Steady and watch the distance–time graph draw a straight line. Its gradient is 8 m/s, the same as the velocity readout. Now choose Speeding up: the line curves upwards. Drag along the distance–time graph until the tangent tool sits at 4 s. It should show a gradient of about 8 m/s, which is the car's speed at that moment. Try 2 s and 6 s too, and notice the gradient grows as the curve gets steeper.